A revised procedure for the design of steel plate shear walls is proposed. In this procedure the thickness of the infill plate is found using equations that are derived from the plastic analysis of the strip model, which is an accepted model for the representation of steel plate shear walls. Comparisons of experimentally obtained ultimate strengths of steel plate shear walls and those predicted...

Micromechanisms of ductile fracturing of DH-36 steel plates subjected to blast-induced pressure loads are studied experimentally using specially designed dynamic testing facilities. The sample geometry is such that it undergoes controllable fracturing, generally initiated near its center and grows first circumferentially and then radially. Selected fractured samples are sectioned normal to the ...

In the present investigation, unidirectional grinding marks were attained on the steel plates. Experiments were then conducted using pins of high purity Al, pure Mg and Al-Mg alloys against the prepared steel plates using an inclined pin-on-plate sliding tester. The inclination angle of the plate was varied in the tests and for each inclination angle, the pins were slid both perpendicular and p...

Self-lubricating polymer compounds are currently used for a wide range of applications such as bearings, gears, and water meters. Under severe conditions such as high pressure, high velocity, and/or high temperatures, the material fails (PV limit). In this study, we investigated the effect of graphite on the tribological properties of polystyrene (PS) with “ball-on-three-plates” tests. Graphite...

OBJECTIVE To determine the microchemical and surface composition of tibial plateau leveling osteotomy (TPLO) plates before and after explantation. SAMPLE POPULATION 7 TPLO plates surgically removed from host dogs 6 to 54 months after implantation; 2 raw unpolished-and-unpassivated 316L TPLO plates; and 2 heat-treated, polished-and-passivated, and cleaned 316L TPLO plates. PROCEDURES Samples...

BACKGROUND In the internal fixation of fractured bone by means of bone-plates fastened to the bone on its tensile surface, an on-going concern has been the excessive stress-shielding of the bone by the excessively-stiff stainless-steel plate. The compressive stress-shielding at the fracture-interface immediately after fracture-fixation delays callus formation and bone healing. Likewise, the ten...

It is recommended that one should not combine different metals in orthopaedic devices. The least noble metal in such a galvanic coupling is more likely to corrode. However, some studies have failed to show increased corrosion when titanium and stainless steel are combined. The aim of this study was to determine the fretting corrosion of the contact areas between screws and plates made of these ...

We conducted an experimental and analytical study to understand the mechanisms and dominant parameters for ogive-nose rods and 7.62mm APM2 bullets that perforate 5083-H116 aluminum armor plates. The 20-mm-diameter, 95-mm-long, ogive-nose, 197g, hard steel rods were launched with a gas gun to striking velocities between 230-370m/s. The 7.62-mm-diameter, 10.7g, APM2 bullet consists of a brass jac...