This paper presents an effective rotor current controller for variable-speed stand-alone doubly fed induction generator (DFIG) systems feeding an unbalanced three-phase load. The proposed current controller is developed based on proportional plus two resonant regulators, which are tuned at the positive and negative slip frequencies and implemented in the rotor reference frame without decomposin...

In this paper, an adaptive nonlinear controller is designed for rotor Surface Permanent Magnet Synchronous Motor (SPMSM) drive on the basis of Input-Output Feedback Control (IOFC), and Recursive Least Square (RLS) method. The RLS estimator detects the motor electromechanical parameters, including the motor iron loss resistance online. Moreover, a Sliding-Mode (SM) observer is developed for onli...

Oil-free microturbomachinery (MTM) are inevitably subjected to base or foundation excitations: passenger and commercial transportation vehicles experiencing intermittent excitation from road conditions, and (multiple) periodic load excitations from internal combustion (IC) engines in turbochargers, for example. Too large base excitations can produce severe damage, even failure, due to hard coll...

Simulation models of a variable-speed, fixed-pitch wind turbine were investigated to evaluate the feasibility of constraining rotor speed and power output without the benefit of active aerodynamic control devices. A strategy was postulated to control rotational speed by specifying the demanded generator torque. By controlling rotor speed in relation to wind speed, the aerodynamic power extracte...

The results of strength and gas dynamic improvement of turbocharger TK-32 axial turbine are presented. Turbocharger was manufactured by LLC “Penzadieselmash” (Penza, Russian) and is used as unit boost for diesel locomotive. The goal of this work was to ensure turbine work capacity when rotor speed is increased by 10% without efficiency reduction. The strain-stress state analysis indicated the r...

Doubly Excited Brushless Reluctance Machine (DEBRM) has gained much attention recently in the area of variable-speed constant-frequency generating systems and adjustable speed drives. Two types of reluctance rotor structure, axially laminated and simple salient rotors, are suggested in the DEBRM development. Due to the unconventional pole number combination of the stator and rotor, performance ...

Determination of the starter torque-speed diagram is a major task in the design or selection of a proper gas turbine starter. In this paper, the maximum power of the MGT-40 gas turbine starter was calculated based on the dynamics of the rotor, start-up logic, and compressor map. In a recent research, the pressure ratio was assumed as a linear function of the rotor speed and the required starter...

This paper describes the speed sensorless vector control method of the parallel connected induction motor drive fed by a single inverter. Speed and rotor fluxes of the induction motor are estimated by natural observer with load torque adaptation and adaptive rotor flux observer. The performance parameters speed and rotor fluxes are estimated from the measured terminal voltages and currents. Fou...

air spindles are one of the main elements of precise machine tools. vibration of these spindles is one of the vital issues necessary for investigation. among parameters which influence air spindle vibrations are rotational speed, compression air method, input nozzle diameter, air gap pressure. in this study using ansys, the effects of air gap thickness on air spindle vibrations have been invest...

In this paper, based on feedback linearization control method and using a special PI (propotational integrator) regulator (IP) in combination with a feed-forward controller, a three-phase induction servo-drive is speed controlled. First, an observer is employed to estimate the rotor d and q axis flux components. Then, two input-output state variables are introduced to control the dynamics of to...