ARTICLE INFO ABSTRACT ARTICLE HISTORY: Received 15 September 2012 Revised 15 August 2013 Accepted 22 August 2013 This paper presents a novel control method to improve the efficiency of low-voltage DC-DC converters at light loads. Pulse Width Modulation (PWM) converters have poor efficiencies at light loads, while pulse frequency modulation (PFM) control is more efficient for the same cases. Swi...

In this paper fractional order averaged model for DC/DC Buck converter in continues condition mode (CCM) operation is established. DC/DC Buck converter is one of the main components in the wind turbine system which is used in this research. Due to some practical restriction there weren’t exist input voltage and duty cycle of converter therefor whole of the wind system was simulated in Matlab/Si...

A CMOS Current-mode DC-DC converter using a quadratic slope compensation scheme is presented. The use of a quadratic slope instead of a conventional linear slope makes a damping factor and a frequency bandwidth of a current feedback loop independent of the converter’s output voltage. Further designing the coefficient of the quadratic slope to be fully dependent of the input voltage, the damping...

This paper introduces a digitally performed current mode and voltage control for the dc-dc step down converter based on voltage to frequency converter where the average values of inductor current and output voltage are obtained. These current and voltage measurement are realized by the voltage control oscillator (VCO) and counters (digital integrator). Such an approach enables full digitalizati...

A non-isolated high voltage gain DC-DC converter has been presented in this paper. The boost, SEPIC and modified SEPIC converters were nalyzed and their performance was compared with the proposed converter. The proposed converter has been designed for the input voltage of 5 V and an output voltage of 150 V with 100 W output power. The efficiency of the converter obtained was 92.5%, which is hig...

The main objective of this paper is to compare the performance between fuzzy controller and proportional integral controller in improving the performance of the DC-DC Buck Converter. The evaluation of the output has been carried out and compared by software simulation using MATLAB. This paper also evaluates the stability of the system with fuzzy controller and PI controller and concludes that t...

This paper includes investigations of power losses in monolithic buck dc-dc converter designed with Cadence on CMOS 0.35 μm process. Input voltage of the designed circuit is equal to 3.6 V and output voltage is regulated to 1.2 V. Evaluated and estimated are power dissipations in the MOS transistor, filter inductor and filter capacitor of the buck converter. Investigated and compared are losses...

This paper presents the implementation of a bidirectional dc-dc converter to protect a battery from overcharging and undercharging. The proposed converter circuit provides low voltage stresses across the switches, higher step-up and step-down voltage gains and efficiency is also high when compared to conventional boost/buck converter. The proposed control circuit controls the charging and disch...

Copyright 2013 KIEEME. All rights reserved. This is an open-access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/3.0) which permits unrestricted noncommercial use, distribution, and reproduction in any medium, provided the original work is properly cited. pISSN: 1229-7607 eISSN: 2092-7592 DOI: http://dx...

In this paper, the dynamics of a DC-DC boost power converter under variable structure control is studied applying bifurcation analysis techniques. The switching hyperplane coefficients are considered as bifurcation parameters. The dynamic phenomena detected in this work suggest new types of sliding bifurcations. This analysis is relevant in the context of sliding mode control with auxiliary ada...