Nozzle clogging is a serious productivity and quality problem in continuous casting. This work reviews the causes, effects, and solutions to clogging in continuous casting nozzles. The results of a one-dimensional, steady state analysis of the heat loss from the molten steel stream through the nozzle wall are discussed. The analyses show that steel may freeze within the clog matrix for a relati...

The yield of flow cytometric sorted Xand Y-chromosome-bearing sperm in a given time period is an important factor in the strategies used for fertilization and the production of sex-preselected offspring. This yield is dependent on the efficiency with which the modified flow cytometer/cell sorter analyzes the DNA of spermatozoa. The efficiency is directly related to the number of sperm with the ...

Direct ink writing (DIW) has demonstrated great potential as a multimaterial multifunctional fabrication method in areas as diverse as electronics, structural materials, tissue engineering, and soft robotics. During DIW, viscoelastic inks are extruded out of a 3D printer's nozzle as printed fibers, which are deposited into patterns when the nozzle moves. Hence, the resolution of printed fibers ...

Experiments on the onset of buoyant instabilities leading to periodic formation of vortical structures in planar buoyant plumes of helium and helium/air mixtures injected into quiescent air are reported for a range of nozzle widths (w520– 70 mm), plume fluid densities ~pure helium to that approaching air!, and velocities at the nozzle exit. First, the plume parameters corresponding to the onset...

the main purpose of this study is to introduce a new method for nanofibers by bulk layer production. in the present method the effect of some parameters including take-up velocity, applied voltage, polymer solution concentration on density of produced layers is investigated. the compression characteristic of nanofiber layers produced under optimum electrospinning is also investigated. it was sh...

Starting flow through a nozzle or orifice typically results in the transient formation of a leading vortex ring and trailing jet. Experiments are conducted to investigate the dynamics of this process in the case of a temporally variable nozzle exit diameter, with the aim of understanding these flows as they occur in Nature and emerging technologies. By kinematically decoupling the source flow f...

Particle beams have traditionally been produced by supersonic expansion of aparticle-ladengas through a single nozzle to vacuum. However, it has been shown that, by passing the particle-laden gas through a series of axi-symmetric subsonic contractions and expansions (an aerodynamic lens system) prior to the supersonic expansion to vacuum through a single nozzle, beam divergence can be signiŽ ca...

The discharge of grains from a hopper or silo has received considerable attention, both because it is relevant to numerous industries, and a model system for examining general features of granular flow [1, 2]. These studies have generally focused on the motion of grains inside the hopper and the flow rate of material out of the nozzle. It is known that these systems can exhibit intermittent jam...

Understanding and controlling mixing and combustion processes is fundamental in order to face the challenges set by the ever more demanding pollutant regulations and fuel consumption standards of direct injection diesel engines. The fundamentals of these processes haven been long studied by the diesel spray community from both experimental and numerical perspectives. However, certain topics, su...

Supersonic separators have found extensive applications in dehumidification of natural gases since 2003. Unlike previous studies, which have investigated the inlet conditions and nozzle geometry of supersonic separators for pure fluids, the present study employed a combination of momentum, heat, and mass transfer equations along with Virial equation of state (EOS) to inspect the effect of inlet...