In this work, an alternative route to fabricating high-quality CH3NH3PbI3 thin films is proposed. Single-source physical vapour deposition (SSPVD) without a post-heat-treating process was used to prepare CH3NH3PbI3 thin films at room temperature. This new process enabled complete surface coverage and moisture stability in a non-vacuum solution. Moreover, the challenges of simultaneously control...

As the phase-out of chlorofluorocarbons (CFC's) approaches, there is a current need for the development of new vapor compression chillers which can operate with non-CFC refrigerants while still maintaining high operating efficiencies. Redesign of the traditional flooded evaporator used in refrigeration chillers so as to incorporate a spray evaporation capability offers both a potential for incr...

This study presents an experimental comparison of energy, exergy flow and second law efficiency of R22 and its substitute R436b (hydrocarbon mixture of 52% of propane (R290) 48% of isobutene (R600a)), vapour compression refrigeration cycles. The vapour compression refrigeration cycle was initially designed to operate with R22. The primary objective of this paper is to analyze the system process...

A novel experimental approach to determine soil hydraulic material properties for the dry and very dry range is presented. Evaporation from the surface of a soil column is controlled by a constant flux of preconditioned air and the resulting vapour flux is measured by infrared absorption spectroscopy. The data are inverted under the assumptions that (i) the simultaneous movement of water in the...

Spontaneous ordering of nanoparticles (NPs) occurring as a consequence of solvent evaporation can yield highly ordered and extended NP superlattices bearing both fundamental scientific interest and potential for technological application. A versatile experimental chamber has been developed allowing (i) controlled in situ deposition of NP solutions on solid substrates, (ii) rate-controlled evapo...

Refrigeration cycle system modelling of the vapor compression experimental unit with the goal to predict the system performance of the cycle and geometry of the helical coil evaporator flooded in the water is presented in the paper. Design of the experimental unit is based on the commercially available scroll compressor and air cooled condenser. In order to determine the thermodynamic condition...

The aim of this study is to find the optimal water pressure and percentage of supply vapour in the feed water heaters (fwhs) of steam power plants, such that they maximize the thermal efficiency of the Rankine cycle within pre-specified values of minimum and maximum pressures of the thermodynamic cycle. Thermal efficiency is defined as a function of unknown variables (fluid pressure and vap...

The aim of this study is to find the optimal water pressure and percentage of supply vapour in the feed water heaters (fwhs) of steam power plants, such that they maximize the thermal efficiency of the Rankine cycle within pre-specified values of minimum and maximum pressures of the thermodynamic cycle. Thermal efficiency is defined as a function of unknown variables (fluid pressure and vap...

In this paper, the physico-chemical basics of the sectional multicomponent aerosol model SEMA are described. SEMA includes condensation and evaporation of sulphuric acid, nitric acid, hydrogen chloride, ammonia, and water vapour. The model can be applied to predictions of the chemical composition and size distribution of aqueous tropospheric secondary and marine aerosols. In SEMA, multicomponen...

The atmospheric radiative forcing is a central theme of climate change impact studies. The presence of Atmospheric Brown Clouds due to increased aerosol concentrations and green house gases such as water vapour, CO2 alter solar radiation and atmospheric thermal regimes. Both have strong feedbacks on open water evaporation. The measured daily global (direct + diffuse) insolation for a period of ...