An extensive study of Higher Alcohol Synthesis (HAS) from synthesis gas using cobalt (Co) promoted alkalized MoS2 catalysts supported on Carbon NanoTubes (CNTs) is reported. Up to  5wt.% of Co is added to the 15wt.% Mo-wt.%K/ CNTs by incipient wetness impregnation method. Most of the metal particles were homogeneously distributed inside the tubes and the rest on the oute...

The novel structure-type Ag(2.54)Tl(2)Mo(12)Se(15) (silver thallium molybdenum selenide) is built up of Mo(6)Se(i)(8)Se(a)(6) and Mo(9)Se(i)(11)Se(a)(6) cluster units in a 1:2 ratio, which are three-dimensionally connected to form the Mo-Se network. The Ag and Tl cations are distributed in several voids within the cluster network. Three of the seven independent Se atoms and one Tl atom lie on s...

introduction: average glandular dose calculation in mammography with mo-rh target-filter and dose calculation for different situations is accurate and fast. material and methods: in this research, first of all, x-ray spectra of a mo target bombarded by a 28 kev electron beam with and without a rh filter were calculated using the mcnp code. then, we used the sobol-wu parameters to write a fortra...

This study utilized Swietenia mahagoni bark–a wood processing industry waste, for the preparation of activated carbon, and then investigated for the removal of methyl orange (MO) dye by the Swietenia mahagoni bark activated carbon (SMBAC). The effect of pH (3–10), adsorbent dose (1–30 g/L), initial MO dye concentration (10–100 mg/L), and contact time (1–240 min) were evaluated...

In this study, a high energy planetary ball milling technique was used to synthesize nano-crystalline Mo-Cu alloys. Molybdenum trioxide (MoO3) and copper oxide (CuO) were used as the starting materials. Carbo-thermal co-reduction of mixed Mo and Cu oxides powders was done with milling followed by a heat treatment at a high temperature. Differential thermal analysis/thermogravimetric (DTA/TG) wa...

In this paper, we consider the following indirect signal generation and logarithmic sensitivity ε n t = Δ − χ ∇ · open="(" close=...

the fabrication of complex-shaped parts out of (wt %) co-28cr-6mo alloy by three-dimensional printing (3dp) was studied using two grades of the alloy with average particle sizes of 20 and 75 μm. to produce sound specimens, 3dp processing parameters were tuned. the sintering behavior of the powders was characterized by the dilatometric analysis. batch sintering in argon atmosphere at 1280 °c for...

In this paper, we obtain the solution forms of fifth order systems rational difference equations P n + 1 = 4 S 2 Q / − 3 ± , </m...