For the new process of effective utilization of energy, chemical recuperation of low-grade exhaust heat by steam reforming of dimethyl ether (DME) was proposed. Steam reforming of DME is an endothermic reaction as; DME + 3H2O + 122[kJ/mol] → 6H2 + 2CO2. If this reaction could be proceed by exhaust heat below 573 [K], those exhaust heat which is wasted to ambient would be recuperated as the fuel...

Catalytic steam reforming of glycerol for H(2) production has been evaluated experimentally in a continuous flow fixed-bed reactor. The experiments were carried out under atmospheric pressure within a temperature range of 400-700 degrees C. A commercial Ni-based catalyst and a dolomite sorbent were used for the steam reforming reactions and in situ CO(2) removal. The product gases were measured...

Currently, hydrogen is mainly produced through steam reforming of natural gas. However, this conventional process involves environmental and energy security concerns. This has led to the development of alternative technologies for (potentially) green hydrogen production. In this work, the environmental and energy performance of biohydrogen produced in Europe via steam reforming of glycerol and ...

Structural changes of a variety of different SnO, SnO2 and GeO2 catalysts upon reduction in hydrogen were correlated with associated catalytic changes in methanol steam reforming. Studied systems include SnO, SnO2 and GeO2 thin film model catalysts prepared by vapour phase deposition and growth on polycrystalline NaCl surfaces and, for comparison, the corresponding pure oxide powder catalysts. ...

Introduction Fuel cells, which produce electricity directly from hydrogen and oxygen, offer a clean and efficient potential alternative to internal combustion engines for generating power for portable and transportation applications. However, there currently is no infrastructure for the wide scale production and distribution of hydrogen to the transportation market. Instead of building new infr...

Producing both hydrogen and high-value carbon nanotubes (CNTs) derived from waste plastics is reported here using a pyrolysis-reforming technology comprising a two-stage reaction system, in the presence of steam and a Ni-Mn-Al catalyst. The waste plastics consisted of plastics from a motor oil container (MOC), commercial waste high density polyethylene (HDPE) and regranulated HDPE waste contain...

Nanostructured Cu(x)Zn(1-x)Al(2)O(4) with a Cu:Zn ratio of ¼:¾ has been prepared by a microwave-assisted hydrothermal synthesis at 150 °C and used as a precursor for Cu/ZnO/Al(2)O(3)-based catalysts. The spinel nanoparticles exhibit an average size of approximately 5 nm and a high specific surface area (above 250 m(2) g(-1)). Cu nanoparticles of an average size of 3.3 nm can be formed by reduct...