This paper presents the design and analysis of Ultra Wideband (UWB) mixer in 65nm CMOS technology. To achieve the optimized performance, a new mixer topology is suggested. The performance parameters of the mixer viz.: conversion gain, Noise Figure, linearity and power consumption are addressed in this paper. The simulation results of the new mixer topology suggested in this paper achieves the r...

We observe direct mechanical mixing in nanoelectromechanical transistors fabricated in semiconductor materials operating in the radio frequency band of 10 ∼ 1000 MHz. The device is made of a mechanically flexible pillar with a length of 240 nm and a diameter of 50 nm placed between two electrodes in an impedance matched coplanar wave guide. We find a nonlinear I-V characteristic, which enables ...

The residence time of liquid and solid was determined in flotation banks of mechanical cells and flotation columns at Salvador Division, Codelco-Chile. The estimation was developed from residence time distribution (RTD) measurements using radioactive tracers. Results allowed the estimation of effective pulp volumes in flotation banks and columns. It was found that industrial flotation banks are...

In this paper, we present results on the noise performance of the waveguide Niobium Titanium Nitride (NbTiN) superconducting hot electron bolometer (HEB) mixers, cryogenically cooled by a 4-K close-cycled refrigerator. The NbTiN superconducting HEB mixer is fabricated on a crystalline quartz substrate, and is mounted in a waveguide mixer block for RF and LO coupling. At 0.81 THz, the uncorrecte...

A highly linear down conversion mixer with moderate gain used for 2.4GHz RF applications is presented in this paper using 0.18μm CMOS technology. The proposed mixer incorporates current bleeding technique & degenerative resistors to improve linearity and conversion gain. Also the negative feedback configuration of the circuit gives flat conversion gain increasing the overall bandwidth. The simu...

In this paper, a 2.4GHz low power downconversion mixer with high linearity for direct-conversion receivers based on a standard 0.18um CMOS technology is proposed. In the circuit design, Gilbert cell architecture and Common-Gate configuration are used. A simple buffer is applied in the IF output. Simulation results show that the mixer can operate at 2.4GHz and obtain the conversion gain of 11.08...

Material Balance around process has been conducted by using mixer output equations. A method based on Mason's theory has been proposed to develop mixer output equations.

The NRAO CDL is preparing to construct test receivers for use in production of the Band-6 mixer-preamps for ALMA. The discussion below applies primarily to the mixer-preamp to test receiver interface, but should also be useful as a guide to the mixer-preamp interface with the cartridges — all the listed connections will be available on the mixer-preamp and can be used as desired by the cartridg...

This paper is a design and implementation of a monitoring and control system for industrial mixer using PLC .This mixer used for an effective, reliable and highly flexible method for the control of processes within an Industrial environment. The objective of this study is to simulate the control an industrial mixer and by doing this we can develop a program that can be used for the actual imple...

We provide the first in situ and real-time study of the effect of milling frequency on the course of a mechanochemical organic reaction conducted using a vibratory shaker (mixer) ball mill. The use of in situ Raman spectroscopy for real-time monitoring of the mechanochemical synthesis of a 2,3-diphenylquinoxaline derivative revealed a pronounced dependence of chemical reactivity on small variat...