The effect of heating rate on the phase trans-formation kinetics of a Ti–10V–2Fe–3Al metastable btitanium alloy quenched from the b field is investigated byfast in situ high energy synchrotron X-ray diffraction anddifferential scanning calorimetry. The initial microstructureis formed by a00 martensite and finexath particles distrib-uted in the retained b-phase matrix...

in this study, the effects cold rolling and annealing parameters during thermomechanical processing of the aisi 201ln stainless steel were investigated. the cast samples were homogenized, hot-rolled and solution-annealed to acquire a suitable microstructure for the subsequent thermomechanical treatment. unidirectional and transverse multi-pass cold rolling at 25, 0 and -15 °c was carried out to...

Nanoindentation measurements were obtained on eight commercially-produced DP980 dual-phase steels to quantify the hardness of the individual constituents, ferrite and martensite, in each steel. Each microstructure was also evaluated to determine grain size, martensite volume fraction (MVF), and retained austenite content. Nanoindentation hardnesses and quantitative microstructural measurements ...

Strain-induced phase transformation and damage accumulation in austenitic stainless steel subjected to cyclic loading were investigated by nondestructive evaluation. The cyclic loading test was performed at various strain amplitudes at the same strain rate. The volume fraction of the strain-induced phase transformation (α′-martensite) was determined by ferrite scope and magnetic coercivity meas...

Stabilization of martensite and two way shape memory effect (TWSME) was studied in Cu-Ai-Mn alloys containing 9.7-11.8 wt% Al, and 3.0-9.25 wt% Mn, which were quenched to various temperatures. The transforming temperatures were in the range -70 to +220°C. The majority of alloys quenched directly to martensite did not show reverse transformation on heating due to stabilization and further temper...

Developing numerical methods for predicting microstructure in materials is a large and important research area. Two examples of material microstructures are Austenite and Martensite. Austenite is a microscopic phase with simple crystallographic structure while Martensite is one with a more complex structure. One important task in materials science is the development of numerical procedures whic...

We present models of the microstructure of martensite that occurs when twinned layers of martensite meet a pure variant. This microstructure often occurs below the A, temperature, with loading that favors the passage from one pure variant of martensite to another. This microstructure gives a mechanism for variant rearrangement. In this microstructure, the layers are observed to pinch down to sh...

Martensitic and bainitic steels are two types of widely used steels with excellent mechanical behaviors in automatic industry. It’s universally acknowledged that asquenched martensite possesses poor ductility and impact toughness, which should be tempered before putting into application. During tempering, as-quenched martensite changes from a hard and brittle microstructure to more ductile and ...

Magnetic Shape-Memory (MSM) materials are a new category of actuator materials with the potential to produce both large actuator strain and rapid response. To explore the possibility of developing MSM materials based on Fe-Ni-Co-Ti alloys, the effects of chemical composition (Co/Ni ratio) and ausaging on microstructure and magnetic shapememory response were studied. A suitable choice of chemica...