References 1Al Taweel, A. M., and Landau, J., “Turbulence Modulation in TwoPhase Jets,” International Journal of Multiphase Flow, Vol. 3, No. 2, 1977, pp. 341–351. 2Gore, R. A., and Crowe, C. T., “Effects of Particle Size on Modulating Turbulent Intensity,” International Journal of Multiphase Flow, Vol. 15, No. 2, 1989, pp. 279–285. 3Schreck, S., andKleis, S. J., “ModiŽ cationofGrid-GeneratedTu...

Quenching cooling rate of rotary hollow cylinder by one row of water impinging jets has been experimentally studied. Water jets (d = 8 mm) with sub-cooling 55 to 85 ◦C and Reynolds number 8,006 to 36,738 impinged over rotary hot hollow cylinder (rotation speed 10 to 70 rpm) with initial temperature 250 to 600 ◦C. Impingement impact angle of row of jets varied between 0 to 135 ◦ and jet-to-jet s...

In this research, a high-temperature Rankin cycle (HTRC) with two-stage pumping is presented and investigated. In this cycle, two different pressures and mass flow rates in the HTRC result in two advantages. First, the possibility of direct recovery from the engine block by working fluid of water, which is a low quality waste heat source, is created in a HTRC. Secondly, by doing this, the mean ...

The present work concerns the activity performed to upgrade an in house finite volume CFD solver for computing heat transfer in gas turbine cooling devices. The “conjugate simulation” of fluid heat transfer and metal heat conduction has been considered. To this aim the original code has been coupled to a new one solving the Fourier equation in the solid domain. This modification allows the “con...

An existing open circuit wind tunnel has been modified to incorporate a secondary supply loop to provide controlled flow conditions at the inlet to a film cooling hole model. The primary or crossflow fluid enters from atmosphere through a smooth two dimensional contraction before entering the working section. The newly constructed supply loop has a single inlet from a high pressure source, in-l...

As commercial and military aircraft engines approach higher total temperatures and increasing overall fuel-to-air ratios, there exists a potential for significant heat release to occur in the turbine if energetic species emitted from the combustor are further oxidized during interaction with film-cooling flows. Currently there is little basis for understanding the effects on aero-performance an...

An experimental/computation investigation was carried out to develop a MEMS-based micro cooling device to provide direct cooling to high heat flux electronics and MEMS devices. This device uses the electrohydrodynamic principles to pump and form an ultra thin film over a heated surface that requires cooling. The important part is played by applying an electric field to a set of interdigitated i...