Input impedance of the respiratory system is measured by forced oscillation technique (FOT). Multiple prior studies have attempted to match the electromechanical models of the respiratory system to impedance data. Since the mechanical behavior of airways and the respiratory system as a whole are similar to an electrical circuit in a combination of series and parallel formats some theories were ...

This paper presents the design of a fully packaged 60 GHz wideband patch antenna incorporating an air cavity and a fused silica superstrate. Circular polarization (CP) is realized by introducing a diagonal slot at the center of the square patch. By optimizing the patch and the slot dimensions, a high efficiency (>90%) microstrip fed CP antenna with an impedance bandwidth of 24% and a 6 dB axial...

Abstract—In this paper, a novel dual-band RF-harvesting RF-DC converter with a frequency limited impedance matching network (M/N) is proposed. The proposed RF-DC converter consists of a dual-band impedance matching network, a rectifier circuit with villard structure, a wideband harmonic suppression low-pass filter (LPF), and a termination load. The proposed dual-band M/N can match two receiving...

Impedance control has been suggested as the strategy employed by the central nervous system to control human postures and movements. A realization of this strategy is presented that uses a model predictive control algorithm as a higher motor controller. External disturbances are explicitly included in the model. The combination of 3 key factors-joint impedance control, model predictive controll...

INTRODUCTION: The purpose of this work is to develop a simple method to achieve the best signal-to-noise ratio (SNR) for a surface coil without the required use of a network analyzer and do so when the coil is under load inside the magnet. In our lab, before imaging, a local coil was connected to the S11 input of a network analyzer and tuned to the resonance at 50 ohm impedance. When remote vol...

Electrical parameters of spinal motoneurons were estimated by optimizing the parameters of motoneuron models to match experimentally determined impedance functions with those of the models. The model was described by soma area, somatic and dendritic membrane resistivities, and the diameter of an equivalent dendritic cable having a standard profile. The impedance functions of motoneurons and opt...

Wireless power transfer based on magnetic resonant coupling can be used to supply a mobile robot within few meters of transmitter coil. However, when the moves or its consumption fluctuates, input impedance varies significantly and, in case mismatch, reflection may occur. To address this issue, we employed driver coil side match impedance. By regulating coefficient between and coils, is matched...

One unfortunate occurrence in experimental measurements with electrical impedance tomography is electrodes which become detached or poorly connected, such that the measured data cannot be used. This paper presents an automatic approach to detect such erroneous electrodes. It is based on the assumption that all valid measurements are related by the image reconstruction model, while the measureme...