نتایج جستجو برای: heat curing
تعداد نتایج: 212612 فیلتر نتایج به سال:
pulling force is one of the most important variables in pultrusion process which determines the capacity of the pultrusion machine. one of the characteristics of a desired pultrusion process is a low pulling force and a high line speed.among the important factors affecting the pulling force are the internal mold release agent (imr) and the content and particle size of the filler in resin formul...
Novel, effective methods to control and prevent spoilage and contamination by pathogenic microorganisms in meat and meat products are in constant demand. Non-thermal pasteurization is an ideal method for the preservation of meat and meat products because it does not use heat during the pasteurization process. Atmospheric pressure cold plasma (APCP) is a new technology for the non-thermal pasteu...
Prepregs of a mixture of the tetrafunctional epoxy tetraglycidyl 4.4-diaminodiphenyl methane (TGDDM) and the tetrafunctional amine 4.4'-diaminodiphenylsulfone (DDS) were characterized with temperature-modulated DSC (TMDSC) as well as dynamic mechanical analysis (DMA). The baseline shift of the glass transition was separated from the curing exotherm by using temperature-modulated and step scan D...
We investigate cross-cut cylindrical heat sink to improve cooling of a light-emitting diode (LED) bulb compared with conventional plate-fin cylindrical heat sinks using various installation angles. In contrast to plate-fin heat sinks, whereby the fins in the upper heat sink do not provide effective cooling at large installation angles, flow formed between the cross-cut fins and the air reached ...
Pulpal temperature changes induced by modern high powered light emitting diodes (LEDs) are of concern when used to cure composite resins. This study showed an increase in pulp chamber temperature with an increase in power density for all light cure units (LCU) when used to bulk cure composite resin. Amongst the three LEDs tested, the Elipar Freelight-2 recorded the highest temperature changes. ...
This paper deals with the control of a powder coating radiative curing process by infrared flow. It is based on a unidirectional dynamic modelling where both heat transfert and cure phenomena are accounted for within the thicknessl. The control problem is the constrained optimization of the curing cycle. This is solved using a special model predictive control framework: it is designed such that...
AIM The aim of this study is to evaluate the dimensional accuracy of heat polymerized acrylic resin denture base clamped by the conventional method and by new-press technique and cured by long curing cycle. MATERIALS AND METHODS In this study, a total of 60 standardized maxillary record bases were fabricated with seven reference points as follows: Point A: Incisive papilla, Point B and C: Can...
STATEMENT OF PROBLEM Poor wettability of denture relining materials may lead to retention problems and patient discomfort. PURPOSE Purpose of this study is to compare and evaluate wettability of nine denture relining materials using contact angle measurements under air and water storage over time. MATERIAL AND METHODS Nine denture relining materials were investigated in this study. Two heat...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید