Fuel cells are new alternative energy resource that has a great promise for distributed generation and electric vehicle application. However, fuel cells have a slow response due to their slow internal electromechanical and thermodynamic response. To optimize the fuel cell system performance, a fuel cell DC-DC converter with an appropriate controller which can regulate the power flow and automat...

This paper presents a hierarchical control strategy for heat and electric power control of a building integrating hybrid renewable power sources including photovoltaic, fuel cell and battery energy storage with Plug-in Electric Vehicles (PEV) in smart distribution systems. Because of the controllability of fuel cell power, this power sources plays the main role for providing heat and electric p...

This paper summarizes experimental results of an air fed polymer electrolyte membrane fuel cell system HyPM XR 12 (Hydrogenics Corp.) considering fuel cell temperature, stoichiometry and load requirement variations at ambient and low pressure operation. The experimental work realized at a low pressure test facility designed and assembled by the German Aerospace Center, Institute of Engineering ...

The cell voltage and power performance of a microbial fuel cell utilizing waste carbohydrate as a fuel, that does not use a mediator, catalysts or a proton exchange membrane, is reported. Tests were conducted with the cell operated essentially as a battery using manure sludge as fuel and with oxygen reduction in an aqueous solution. Using carbon cloth as anode and cathode, the cell produced pea...

This paper presents the performance analysis of a planar solid-oxide fuel cell (SOFC) under direct internal reforming conditions. A detailed olid-oxide fuel cell model is used to study the influences of various operating parameters on cell performance. Significant differences in efficiency nd power density are observed for isothermal and adiabatic operational regimes. The influence of air numbe...

sulfonated poly (ether ether ketone) (speek) with a low degree of sulfonation (ds = 40%) was prepared for proton exchange membrane fuel cells (pemfc). poly (ether ether ketone) (peek) was sulfonated in concentrated h2so4 under n2 atmosphere and characterized by the hydrogen nuclear magnetic resonance (h-nmr) technique. after preparation of the speek polymer, the obtained polymer was dissolved i...

Using COMSOL Multiphysics 3.5, a numerical model has been developed to determine the effect of the channel geometry and electrode configuration on cell performance based on polarization curves. The Butler-Volmer equation was implemented to determine the reaction rates at the electrodes. The Conductive Media DC module is used to model the electric fields within the fuel cell. The concentration d...

High-Performance Alkaline Direct Methanol Fuel Cell using a Nitrogen-Postdoped Anode Report Title A commercial PtRu/C catalyst postdoped with nitrogen demonstrates a significantly higher performance (?10–20?% improvement) in the anode of an alkaline direct methanol fuel cell than an unmodified commercial PtRu/C catalyst control. The enhanced performance shown herein is attributed at least parti...

*Correspondence: Peiwen Li , Department of Aerospace and Mechanical Engineering, The University of Arizona, 1130 North Mountain Avenue, Tucson, AZ 85721, USA e-mail: [email protected] In this study, a significant number of experimental tests to proton exchange membrane (PEM) fuel cells were conducted to investigate the effect of gas flow fields on fuel cell performance. Graphite plates w...