Damage and fracture mechanisms of two 2198 Al-Li thin sheet alloys having different thicknesses (2 and 6 mm) are investigated. Two heat treatments are studied: T3 and T8. Mechanical tests are carried out on flat specimens including smooth tensile samples and U-notched specimens (with various notch radii). Test data are used to identify the parameters of constitutive equations describing plastic...

The premature breakage in some four cylinder diesel engine crankshafts was reported. All crankshafts were failed from the same region. Failures had occurred in the first crankpin, the nearest crankpin to the flywheel. Dynamic analysis and finite element modelling were carried out to determine the state of stress in the crankshaft. FEM results revealed that the first crankpin fillet is the most ...

Bedrock fracture systems facilitate weathering, allowing fresh mineral surfaces to interact with corrosive waters and biota from Earth's surface, while simultaneously promoting drainage of chemically equilibrated fluids. We show that topographic perturbations to regional stress fields explain bedrock fracture distributions, as revealed by seismic velocity and electrical resistivity surveys from...

A wall/plasma membrane unit was prepared from Hydrodictyon africanum by microdissection. A replica of the inner surface of the membrane was made and by freeze-fracture of the whole cell, 2 corresponding internal fracture faces were obtained. The large coenocytes of the alga were plasmolysed and the wall separated by cutting it away. Its inner surface was directly viewed in the electron microsco...

This article describes a new freeze-fracture autoradiographic technique for the detection of radioactive ligands associated with the surface of cells in monolayer or suspension culture. Since freeze-fracture replicas are produced in the conventional way, all membrane features normally seen in freeze-fracture are retained, and autoradiographic grains produced by the labeled ligands are seen supe...

The fracture behaviour of polymers is strongly affected by the addition of rigid particles. Several features of the particles have a decisive influence on the values of the fracture toughness: shape and size, chemical nature, surface nature, concentration by volume, and orientation. Among those of thermoplastic matrix, polypropylene (PP) composites are the most industrially employed for many di...

The feasibility of predicting the fracture behavior of surface cracks from shallow cracked bend specimens was investigated. The material studied was a high-strength steel stress relief embrittled to various levels of Charpy-V notch impact toughness. Material toughness was quantified in terms of the J-intergral at total specimen failure (-/„,,), using both deeply notched and shallow-notched bend...

In this study, the effect of surface roughness and roughness morphology on the bond strength of WC-Co-Cr coatings has investigated. The three different surfaces morphology are use for this purpose. The first and tow samples sandblasted with alumina and silicon carbide respectively. Other sample no sandblasted before spraying process. The same WC-10Co-4Cr coating deposited on the substrates with...