this research work is devoted to experimental and theoretical evaluations of a hybrid constitutive model which was designed to simulate the mechanical behavior of a tread rubber compound. the model is a combination of yeoh hyperelastic model with a strain-rate hysteresis model developed by bergstrom and boyce. the parameters of the yeoh model were calibrated from experimental data of the astm d...

afinite element model of a bias truck tire under static vertical load using a global/local technique is designed in two parts. in the first part a previously created model for radial tires is developed to take the constructional variables of bias tires into account. it is shown that the technique can successfully be used for bias tires. the main challenge here is the selection of the initial la...

electrostatic potential as well as the local volume charge density are computed for a macromolecule by solving the poisson-boltzmann equation (pbe) using the finite element method (fem). as a verification, our numerical results for a one dimensional pbe, which corresponds to an infinite-length macromolecule, are compared with the existing analytical solution and good agreement is found. as a ma...

stability of foundations near slopes is one of the important and complicated problems in geotechnical engineering, which has been investigated by various methods such as limit equilibrium, limit analysis, slip-line, finite element and discrete element. the complexity of this problem is resulted from the combination of two probable failures: foundation failure and overall slope failure. the curr...

superplastic materials show a very high ductility. this is due to both peculiar process conditions and material intrinsic characteristics. however, a number of superplastic materials are subjected to cavitation during superplastic deformation. evidently, extensive cavitation imposes significant limitations on their commercial application. the deformation and failure of superplastic sheet metals...

this paper presents an overview of model updating and particularly its application for updating of frame model. in this article a mathematical model of the frame was produced with finite element method. the frame was subjected to hammer modal testing. then the results of the modal testing were compared with those predicted with the model. this comparison revealed discrepancies between these two...

We describe a hybrid method which combines the boundary element method (BEM) and the finite element method (FEM) to compute circuit models for layout dependent capacitances. The method can handle irregularities in the stratification of the layout of the integrated circuits (IC’s). New in the method are the models for the interface between the regions where the BEM and the FEM are applied. We sh...

this paper presents a method for diagnosis of eccentricity fault in a switched-reluctance motor (srm) during offline and standstill modes. in this method, the fault signature is differential induced voltage (div) achieved by injecting diagnostic pulses to the motor windings. it will be demonstrated by means of results that there is a correlation between differential induced voltage and eccentri...

one of the bellows producing method is hydroforming process .whereas some factor of hydroforming process specially internal pressure affects on final characteristics produced bellows such as bursting, wrinkling and wall thickness distribution. in this paper the effect of internal pressure factor in final quality of produced bellows will be investigated. in simulation of process, abaqus/explicit...