shot peening applies a residual compressive stress field (rcsf) on the surface of parts. it also shifts “crack nucleation sites” to sub-surface locations. a nondestructive method of measuring the stresses, sin2ψ was utilized here and the stress values introduced to ansys software. for this purpose, uniform stress in all directions was applied on the con rod. loading on the rod in ansys had thre...

A modified strip-yield model has been developed to simulate the plasticity-induced crack closure under the constant amplitude (CA) and a single overload loading conditions. The paper focuses on the simulation of the near tip crack profiles and stress distributions during the fatigue process. Detailed information on near-tip stress and displacement fields at the maximum load (Pmax), the minimum ...

This paper presents the effects of different amounts of reclaimed asphalt on fatigue life of asphalt mixtures. Central composite method was used to design of experiments based on response surface method (RSM). Binder type (Pen 60/70 and Pen 85/100), reclaimed asphalt pavement (RAP) content (25, 50 and 75%) and loading strain (150, 250 and 350 micro strain) were selected as independent variables...

present work shows the numerical determination of fatigue crack opening and closure stress intensity factors of a C(T) specimen under variable amplitude loading using a finite element method. A half compact tension C(T) specimen, assuming plane stress constraint was used by finite element method covering the effects in two-dimensional (2D) small scale yielding models of fatigue crack growth und...

The available learning and forgetting models do not consider the physical loading that performing a task requires. In some situations, physical loading results in workers’ fatigue on the job that is followed by rest breaks to alleviate it. The aim of this paper is to present the "learningforgetting-fatigue-recovery model" (LFFRM) that addresses possible issues relating to workers’ capabilities ...

This paper summarizes a series of studies on the interface of fiber reinforced polymer laminates externally bonded to concrete substrates, carried out in the Laboratory of Engineering for Maintenance Systems, Hokkaido University. Appropriate test methods and bond models for shear bond, tensile bond and cleavage bond (bond under dowel force) are shown. Finally, experimental results on shear bond...

Human dentin is susceptible to failure under repetitive cyclic-fatigue loading. This investigation seeks to address the paucity of data that reliably quantify this phenomenon. Specifically, the effect of alternating vs. mean stresses, characterized by the stress- or load-ratio R (ratio of minimum-to-maximum stress), was investigated for three R values (-1, 0.1, and 0.5). Dentin was observed to ...

The aim of the present research is to investigate the fatigue behaviour of friction stir (FS) welded tubular joints in aluminium alloy subjected to torsional fatigue loading. To manufacture the samples which were tested, an MTS I-STIR process development system was equipped with a retracting tool specifically designed for these tubular welds. Al 6082-T6 FS welded samples were tested under cycli...

The aim of this paper is to analyse the dissipation observed during dynamic fatigue loading at low stress range and high number of cycles. Infrared thermographic techniques were developed to estimate the mean dissipation per cycle. Results derived from tests performed at high loading frequency on pure copper specimens showed a drift of dissipative regimes incompatible with concepts of fatigue l...