AIM The aim of this study was to assess whether significant meniscal extrusion of more than 3 mm or of even lesser degrees of extrusion could be considered significant. We also aimed to determine the morphology of tears that are most likely to be associated with significant extrusion. Study design and material. The study was done retrospectively on a group of 202 patients (157 males and 45 fema...

We developed a 3D-printing process based on thermoset biocomposites termed Delayed Extrusion of Cold Masterbatch (DECMA). DECMA is processing method, controlling the degree curing, that takes some responsibility 3D printing from materials and as such can be used to print otherwise unprintable materials. First, masterbatch was produced by mixing bio-based resin (bioepoxy) sawdust lignin. This pa...

The extrusion of section from round billet poses a great challenge for theoretical modeling of the process using upper bound method. The greatest difficulty in three-dimensional upper bound method is to determine kinematically admissible velocity field. The SERR (Spatial Elementary Rigid Region) technique is fairly applicable for analyzing extrusion of sections having re-entrant corners. A modi...

Introduction: To investigate Ca(OH)2 extrusion from the apical foramen in relation to the placement mode. Methods: 200 teeth, prepared with ProTaper files with and without apical patency, were divided in Groups A and B respectively, and filled with Ca(OH)2 at 1 and 3 mm short of working length, using K-files manually and with mechanical spiral techniques (Pastinject/Lentulo) at 500 and 700rpm. ...

The article presents the results of development and research various technological schemes process stamping by rolling cylindrical conical rolls to obtain complex profile workpieces. It is shown that achievement significant dimensions elements workpiece possible providing a directed flow metal changing relative position roll workpiece. most effective operations are landing, settling, unloading,...

immature teeth have a large apical opening and thin divergent or parallel dentinal walls; hence, with conventional needle irrigation there is a very high possibility of extrusion. this study was done to compare the apical extrusion of naocl in an immature root delivered using endovac and needle irrigation.eighty freshly extracted maxillary central incisors were decoronated followed by access ca...

We have presented a second case of heterotopic pregnancy after IVF-ET. The most likely cause is direct extrusion of embryos through the tubal ostia by the hydrostatic pressure associated with ET. The diagnosis of ectopic pregnancy must be suspected clinically and not ruled out on the sonographic demonstration of an intrauterine pregnancy. Early diagnosis is essential for the prevention of signi...

The target was to study and develop industrially suitable methods to apply thermoplastic coatings on plywood. Typically, wear and climatic resistance for wooden sheets, such as chip board and plywood, is achieved by thermosetting resin coating (e.g. phenolformaldehyde). However, economical and environmental issues are driving towards thermoplastic coatings (e.g. polyethylene) in such products. ...