Atomic substitution in alloys can efficiently scatter phonons, thereby reducing the thermal conductivity in crystalline solids to the "alloy limit." Using In0.53Ga0.47As containing ErAs nanoparticles, we demonstrate thermal conductivity reduction by almost a factor of 2 below the alloy limit and a corresponding increase in the thermoelectric figure of merit by a factor of 2. A theoretical model...

The thermal conductivity of solid biomass fuels is useful information in the investigation of biomass combustion behavior and the development of modeling especially in the context of large scale power generation. There are little published data on the thermal conductivity of certain types of biomass such as wheat straw, miscanthus, and torrefied woods. Much published data on wood is in the cont...

Accurate knowledge of thermophysical properties is needed to predict and optimize the thermal performance of microsystems. Thermal conductivity is experimentally determined by measuring quantities such as voltage or temperature and then inferring a thermal conductivity from a thermal model. Thermal models used for data analysis contain inherent assumptions, and the resultant thermal conductivit...

LaCl₃ doped polycrystalline SnSe was synthesized by combining mechanical alloying (MA) process with spark plasma sintering (SPS). It is found that the electrical conductivity is enhanced after doping due to the increased carrier concentration and carrier mobility, resulting in optimization of the power factor at 750 K combing with a large Seebeck coefficient over 300 Μvk-1. Meanwhile, all the s...

This paper contains new, representative equations for the thermal conductivity of normal and parahydrogen. The equations are based in part upon a body of experimental data that has been critically assessed for internal consistency and for agreement with theory whenever possible. Although there are sufficient data at normal temperatures, data at very low or very high temperatures as well as near...

Theoretical model for predicting effective thermal conductivity (ETC) of metal filled polymer composites has been developed. The concept of averaging the temperature field within different phases has been used. Resistor model has been applied to determine ETC of polymer composites. A parameter estimation technique has been applied to determine the inclination angle θ. An effort has been made to...

An analytic robust model is developed for estimating GDL thermal conductivity. The model considers PTFE addition to the GDL. Thermal conductivity of MPL is accurately measured in a compression range of 2e14 bar. Effect of thermal conductivity on PTFE, MPL, and compression is considered. Thermal contact resistances between GDL and MPL/iron surface are measured. a r t i c l e i n f o

An industrial ceramic thermal-barrier coating designated PWA 266, processed by electron-beam physical-vapor deposition, was measured using a steady-state thermal conductivity technique. The thermal conductivity of the mass fraction 7 % yttria-stabilized zirconia coating was measured from 100 °C to 900 °C. Measurements on three thicknesses of coatings, 170 μm, 350 μm, and 510 μm resulted in ther...

The thermal conductivity of group-IV semiconductors (silicon, germanium, diamond and grey tin) with several isotopic compositions has been calculated from a kinetic-collective model. From this approach, significantly different to Callaway-like models in its physical interpretation, the thermal conductivity expression accounts for a transition from a kinetic (individual phonon transport) to a co...

In this work we investigate the thermal conductivity of graphene-based antidot lattices. A third nearest-neighbor tight-binding model and a forth nearest-neighbor force constant model are employed to study the electronic and phononic band structures of graphene-based antidot lattices. Ballistic transport models are used to evaluate the electronic and the thermal conductivities. Methods to reduc...