This paper presents dc-dc converter operation of boost converter are an enabling soft switching technology. This proposed converter configuration can achieve zero voltage switching. The circuit consists of a general boost Converter with an auxiliary circuit which has a additional switch, and resonant components (snubbers). Boost converter has loss mechanism, current stress and voltage stress. b...

─ This paper presents a voltage doubler in to a half bridge converter is derived for electric vehicle battery chargers. The proposed converter provides wide ZVS range, reduced circulating current and also voltage stress. Circulating current during the freewheeling phases of phase shift full bridge circuit are reset by the sum of LLC circuit output voltage and resonant capacitor voltage by achie...

This paper presents passive boost converter fed three phase switched reluctance motor using PI Controller. The operating mode of proposed converter circuit is discussed. The proposed converter is capable of minimizing the torque ripple because of faster excitation and demagnetization and also improving the average torque compared to the conventional converter circuit. The objective of this pape...

A high step-up DC-to-DC converter that integrates an isolated transformer and a switched-clamp capacitor is presented in this study. The voltage stress of the main power switch should be clamped to 1/4 V by using the turn ratio and switched-clamp capacitor of an isolated transformer to achieve a high voltage gain. In addition, a passive clamp circuit is employed reduce voltage stress on the mai...

The conventional AC/AC matrix converter uses 9 bidirectional switches. The 3×3 switches give 512 combinations of switching states, which are decreased to only 27 feasible states, if the two basic rules (preventing the short-circuit and open-circuit) to operate the converters safely are applied. The output voltage of a basic matrix converter is limited to 866 . 0 2 3 ≈ of the input voltage. In t...

3.3kV high speed IGBT module was developed. Optimized lifetime control realized drastically decreasing of both of turn off loss and recovery loss. This high speed characteristic is suitable for bi-directional and medium frequency application such as resonant DC/DC converter. IGBT switching and diode reverse recovery behaviour at resonant DC/DC converter modelled circuit were demonstrated. Obvio...

Among PWM power conversion topologies, the single-switch forward topology is the one that has been most widely used for decades. Its popularity has been based on many factors, including its low cost, circuit simplicity and high efficiency. However, several issues need to be addressed when using the forward converter such as the core reset, the voltage spikes caused by the transformer leakage in...

A low-side switch is a MOSFET or an IGBT that is connected to the ground-referenced and is not floating. In a boost converter, the source terminal of the MOSFET is connected to the circuit ground, which is referred to a low-side MOSFET. To switch an N-channel MOSFET of a boost converter on, the V should be in the order of 10 to 20V. Since the source terminal is grounded, this implies that the g...

A novel bidirectional DC-DC converter is presented in this paper. The circuit configuration of the proposed converter is very simple. The proposed converter employs a coupled inductor with same winding turns in the primary and secondary sides. In step-up mode, the primary and secondary windings of the coupled inductor are operated in parallel-charge and series-discharge to achieve high step-up ...

A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...