This paper studies the addition of fibers from end-of-life tires to commercial mortar mixtures. Two different types of mortar, one lime-plastic and other cement-fluid, are mixed with different percentage of fibers ranging from 0% to 1%. The changes in bulk density, consistency, compressive and flexural strength, dynamic Young modulus and water absorption are studied. According to the results, c...

A model that describes hydration and heat-mass transport in Portland cement mortar during steam curing was developed. The hydration reactions are described by a maturity function that uses the equivalent age concept, coupled to a heat and mass balance. The thermal conductivity and specific heat of mortar with water-to-cement mass ratio of 0.30 was measured during hydration, using the Transient ...

Ozone treatment of isotropic-pitch-based carbon fiber was found to increase the surface oxygen concentration and change surface oxygen from C–O to CNO, thereby causing the contact angle between fiber and water to be decreased to zero. Thus, the bond strength between fiber and cement paste was increased and the tensile strength, modulus and ductility of carbon fiber reinforced cement paste were ...

In this study the effect of using multi-walled carbon nanotube (MWCNT) on flexural and compressive strengths, ultimate displacement and energy absorption capability of standard cement mortar considering different weight percentages of nanotubes as well as different dispersion methods has been investigated. Influential point in adding nanotubes to the composites is their proper dispersion, which...

Incidents of injuries caused by tiles falling from building exterior walls are frequently reported in Taiwan. Humidity is an influential factor in tile deterioration but it is more difficult to measure the humidity inside a building structure than the humidity in an indoor environment. Therefore, a separable microsensor was developed in this study to measure the humidity of the cement mortar la...

X-ray microtomography can be used to generate three-dimensional 5123 images of random materials at a resolution of a few micrometers per voxel. This technique has been used to obtain an image of an ASTM C109 mortar sample that had been exposed to a sodium sulfate solution. The three-dimensional image clearly shows sand grains, cement paste, air voids, cracks, and needle-like trystah growing in ...

Since the establishment of ASTM standard C91, masonry cement mortars have become widely used for masonry construction in low to moderate seismic regions. However, the Masonry Standards Joint Committee Code prohibits the use of masonry cement mortars in lateral force resisting systems for structures that fall into Seismic Design Categories D, E, and F. The general objective of this study is to e...

The paper compared the effect of additives such as FeSO4.7H2O and SnCl2.2H2O on reduction of water soluble Cr(VI), in ordinary Portland cement (43 grades). The determination of water soluble Cr(VI) from cement samples was precisely conducted by DPC-Spectrophotometer technique. The compressive strength testing of the cement mortar samples was carried out. In addition, hydration properties of cem...

This study investigated the basic mechanical and microscopic properties of cement produced with metakaolin and quantified the production of residual white efflorescence. Cement mortar was produced at various replacement ratios of metakaolin (0, 5, 10, 15, 20, and 25% by weight of cement) and exposed to various environments. Compressive strength and efflorescence quantify (using Matrix Laborator...