Force sensor has been used as requisite for knowing information on the amount and the directions of forces on the skin surface. We have developed a four-degrees-of-freedom capacitive force sensor (approximately 20×20×5 mm) that has a flexible structure and sixteen parallel plate capacitors. An iterative algorithm was developed for estimating four displacements from the sixteen capacitances usin...

A wireless passive sensor array based on inductive-capacitive (LC) resonant circuits capable of simultaneously tracking two points of force loading is described. The sensor consisted of a planar spiral inductor connected to two capacitors forming a resonant circuit with two resonant frequencies. When a load was applied to one or both of the parallel plate capacitors, the distance between the pl...

This paper presents a new force-sensitive surface designed for playing music. A prototype system has been implemented using a passive capacitive sensor, a commodity multichannel audio interface, and decoding software running on a laptop computer. This setup has been a successful, lowcost route to a number of experiments in intimate musical control.

In this paper a multi-disciplinary simulation of a capacitive droplet sensor based on an open plate capacitor as transducing element is presented. The numerical simulations are based on the finite volume method (FVM), including calculations of an electric field which changes according to the presence of a liquid droplet. The volume of fluid (VOF) method is applied for the simulation of the ejec...

There are fewer problems encountered with optical voltage transducers in comparison with their inductive and capacitive counterparts. Although capacitive and inductive transformers are used vastly for the purpose of measurement and protection in the networks, they cause problems such as core saturation and improper transient responses which decrease the accuracy of measurement and eficiency of ...

In this paper, a four-point characterization method is developed for samples that have either capacitive or ohmic contacts. When capacitive contacts are used, capacitive current- and voltage-dividers result in a capacitive scaling factor not present in four-point measurements with only ohmic contacts. From a circuit equivalent of the complete measurement system, one can determine both the measu...

Based on a capacitive angle and angular rate sensor, a sensor measuring the relative angle between two rotating shafts has been developed. Two rotatable electrodes are placed between two sensor plates. The relative angle between the two rotors and the absolute position of the rotor blades are calculated from measurements of the capacitive coupling between different transmitting stator segments ...

Electrostatic actuation of motion is commonly used in resonant MEMS. Drive signal feed-through is undesirable as it masks the detection signal. This paper reports analysis and demonstration of a resonant motion excitation scheme, which uses a combination of a DC bias with a sinusoidal AC voltage, frequency of which is twice of the mechanical resonant frequency. This configuration is experimenta...

Capacitive and inductive crosstalk noises are expected to be more serious in advanced technologies. However, capacitive and inductive crosstalk noises in the future have not been concurrently and sufficiently discussed quantitatively, though capacitive crosstalk noise has been intensively studied solely as a primary factor of interconnect delay variation. This paper quantitatively predicts the ...