In a recent decade, application of nanofluid as a candidate for heat transfer medium has gaining an increasing attention due to its unique advantages. In the light of its unique advantages, it has been utilized in different industries such as oil and gas industries. In this work aims at improving thermal conductivity of the water-based drilling fluid by using the CuO nanofluid additive. CuO nan...

An analysis of the steady mixed convection boundary layer flow past a vertical permeable surface embedded in a porous medium saturated by a nanofluid is performed in this study. Numerical solutions of the similarity equations are obtained using the shooting method. Three types of metallic or nonmetallic nanoparticles, namely Copper (Cu), Alumina (Al2O3) and Titania (TiO2) are considered by usin...

A suspension of particles below 100 nm in size, usually termed as nanofluid, often shows a notable enhancement in thermal conductivity, when measured by the transient hot-wire method. In contrast, when the conductivity of the same nanofluid is measured by the laser flash method, the enhancement reported is about one order of magnitude lower. This difference has been quantitatively resolved for ...

The preparation of nanofluids is very important to their thermophysical properties. Nanofluids with the same nanoparticles and base fluids can behave differently due to different nanofluid preparation methods. The agglomerate sizes in nanofluids can significantly impact the thermal conductivity and viscosity of nanofluids and lead to a different heat transfer performance. Ultrasonication is a c...

Using a unique, near-field microscopy technique, fringe patterns and nanoparticle motions are visualized immediately following a nanofluid droplet deposition on a glass substrate in which an air bubble is entrapped. The nanofluid consists of DI-water, 0.10% Aluminum Oxide nanoparticles with an average diameter of 50 nm, and 0.0005% yellow-green polystyrene fluorescent particles of 1 μm diameter...

In this article, laminar flow-forced convective heat transfer of Al2O3/water nanofluid in a triangular duct under constant wall temperature condition is investigated numerically. In this investigation, the effects of parameters, such as nanoparticles diameter, concentration, and Reynolds number on the enhancement of nanofluids heat transfer is studied. Besides, the comparison between nanofluid ...

in this paper, experimentally derived correlations of heat transfer and pressure drop are used in a pareto based multi-objective optimization (moo) approach to find the best possible combinations of heat transfer and pressure drop of tio2-water nanofluid flow in tubes fitted with multiple twisted tape inserts in different arrangement. in this study there are four independent design variables: t...

The boundary layer flow of Cu-water based nanofluid with heat transfer over a stretching sheet is numerically studied. Second order velocity slip flow model is considered instead of no-slip at the boundary. The governing partial differential equations are transformed into ordinary one using similarity transformation, before being solved numerically. Numerical solutions of these equations are ob...

One of the effective methods to improve the thermal efficiency of solar collectors is using nanofluids as the coolant. The present study experimentally investigated the effect of SiO2/water nanofluid with 1% mass fraction on the performance of a symmetric collector, i.e. conical solar collector. The conical solar collector with 1 m2 area and normal to the earth was tested in Ahvaz, a city in th...

In this study we applied thermal lens (TL) technique to study the effect of size on thermal diffusivity of cadmium sulphide (CdS) nanofluid prepared by using γ-radiation method containing particles with different sizes. In TL experimental set up a diode laser of wavelength 514 nm and intensity stabilized He-Ne laser were used as the excitation source and the probe beam respectively, respectivel...