OBJECTIVE The oral environment is subject to biofilm accumulation and cariogenic challenge, and few studies exist on the effect of these factors on the bond strength of adhesive systems. The aim of this study was to test if the exposure of adhesive interfaces to cariogenic challenge under biofilm accumulation could promote higher degradation than the exposure to biofilm accumulation alone. MA...

Objectives The aim of this study is to compare the shear bond strengths of ceramic brackets bonded to zirconia surfaces using different zirconia primers and universal adhesive. Materials and Methods Fifty zirconia blocks (15 × 15 × 10 mm, Zpex, Tosoh Corporation) were polished with 1,000 grit sand paper and air-abraded with 50 µm Al2O3 for 10 seconds (40 psi). They were divided into 5 groups:...

OBJECTIVES This study evaluated the influence of chlorhexidine (CHX) on the microtensile bonds strength (µTBS) of resin core with two adhesive systems to dentin in endodontic cavities. MATERIALS AND METHODS Flat dentinal surfaces in 40 molar endodontic cavities were treated with self-etch adhesive system, Contax (DMG) and total-etch adhesive system, Adper Single Bond 2 (3M ESPE) after the fol...

OBJECTIVES To evaluate the effect of double-application of all-in-one adhesives using the micro-shear bond test. METHODS The occlusal surfaces of extracted human third molars were ground perpendicular to the long axis of each tooth to expose a flat dentin surface. Three commercially available and one experimental bonding system were used in this study: Adper Prompt L-Pop (APL, 3M ESPE), REACT...

OBJECTIVES Adhesive systems are continuously being introduced to Dentistry, unfortunately often without sufficient clinical validation. The aim of this study was to evaluate the clinical performance of cervical restorations done with three different adhesive systems. MATERIAL AND METHODS 158 non-carious cervical lesions of 23 patients were restored with a nanofilled composite resin (Filtek Su...

BACKGROUND Ozone water can be used to eliminate micro-organisms from the water systems in dental offices. OBJECTIVES To determine if ozone water diminishes the bond strength of orthodontic adhesives. METHODS One hundred and twenty bovine mandibular incisors were randomly divided into four equal groups. The teeth were cleaned with pumice and washed either with tap water (Groups 1 and 3) or w...

INTRODUCTION: The use of flowable composites as an orthodontic bonding adhesive merits great attention because of their adequate bond strength, ease of clinical handling and reduced number of steps in bonding. OBJECTIVE: The aim of this Randomized Controlled Trial was to comparatively evaluate over a 6-month period the bond failure rate of a flowable composite (Heliosit Orthodontic, Ivoclar ...

UNLABELLED Interface integrity can be maintained by setting the composite in a layering technique and using liners. OBJECTIVE The aim of this in vitro study was to verify the effect of resin-modified glass-ionomer cement (RMGIC) lining and composite layering technique on the bond strength of the dentin/resin adhesive interface of lateral walls of occlusal restorations. MATERIAL AND METHODS ...