a simple method is described for analysis of transients in power network. the method is developed for analysis of transformer and generator winding resonances due to their interaction with transmission lines caused by switching surges. the method is already used for calculation of overvoltages which had resulted in damages in the transformer winding of a hydro power plant. nonlinearity in the i...

This paper reports a study into the effect of winding type on stressed-strained state wall steel cylindrical tank filled with oil to predefined level. The shapes free oscillations in and natural frequencies structure were analyzed. Stress was estimated basis finite-element simulation deformation three-dimensional structural model under influence distributed pressure inner surface stresses outer...

Abstract In this work, the non-liner voltage distribution in transformer winding is investigated that occurs due switching and lightning. Transformer winding is modeled in the alternative transients program (ATP) version of Electromagnetic transients program (EMTPRV). EMTP software is used to simulate the very fast transient overvoltage. An experimental setup that consist of , Recurrent surge g...

This paper presents a parametric low differential order model, suitable for mathematically analysis for Induction Machines with faulty stator. An adaptive Kalman filter is proposed for recursively estimating the states and parameters of continuous–time model with discrete measurements for fault detection ends. Typical motor faults as interturn short circuit and increased winding resistance ...

The article presents an analysis of the winding type influence on the efficiency of an induction motor. The aim of this work is to choose such a type of stator winding that the induction motor will have the best efficiency by employing minimum winding (copper) mass. Three types of stator windings were considered in the analysis: concentric single layer winding, concentric double layer winding a...

Inductive magnetic probes are often used to measure oscillating magnetic fields in plasma.r3 The sensitivity of a magnetic probe to electrostatic potentials (“capacitive pickup”) is usually an important consideration. Centertapped construction of such a probe, shown in Fig. 1 (b), helps to minimize capacitive pickup with respect to a simply wound probe [Fig. 1 (a)]. This relies on the fact that...

Cable wound electric machines are used mainly for high voltage and direct-drive applications. They can be found in areas such as wind power, hydropower, wave power and high-voltage motors. Compared to conventional winding techniques, cable winding includes fewer manufacturing steps and is therefore likely to be better suited for automated production. Automation of the cable winding production s...

Cable winding is an alternative technology to create stator windings in large electrical machines. Today such cable winding is performed manually, which is very repetitive, time-consuming and therefore also expensive. This paper presents the design, function and control system of a developed cable feeder tool for robotized stator cable winding. The presented tool was able to catch a cable insid...

Partial Discharge (PD) is the most important source of insulation degradation in power transformers. In order to prevent catastrophic failures in transformers, PDs need to be located as soon as possible so that maintenance measures can be taken in time. Due to the structural complexity of windings, locating the PD source inside a transformer winding is not a simple task. In this paper, the effi...