The purpose of this study was to evaluate the effect of degradation of a denture base resin on bond strength to relining resins. Denture base resin specimens were immersed under various conditions to simulate degradation. Tensile bond strength of denture base resin after immersion to relining resins was measured with or without surface grinding. The bond strength of denture base resin without g...

background and aim: present study was designed to compare the bonding strength of resin-modified glass ionomer (rmgi) and composite resin to mineral trioxide aggregate (mta), mta mixed with na2hpo4 (namta), and calcium-enriched mixture (cem). materials and methods: thirty specimens of each cem, namta, and mta were prepared. composite and rmgi restorations were then placed on the samples (15 sam...

reduced adsorption of NO3–N and NH4–N by anionic and cationic resins, respectively. Kjonaas (1999) also Ion exchange resins have widely been used in mineralization studies observed no detectable effect of freezing on resin staof organic materials. However, the stability of resin (anionic and cationic) under changing physical environmental conditions is not bility. Lehmann et al. (2001) have obs...

Poor wetting leads to underperforming composite properties and has been a major obstacle in implementing low cost carbon fibers in SMC parts. The objective of this project is to solve the technical challenge of poor carbon fiber wet-through during Sheet Molding Composite (SMC) process. Continental Structural Plastics (CSP) partnered with ORNL to develop a new sizing technique called Point Sizin...

Introduction: Acrylic resins have been used successfully as denture bases. However, acrylic resin denture base materials are brittle and have poor strength and thermal conductivity. Therefore, it is essential to improve the flexural strength of heat polymerized acrylic resin. The present study aimed to evaluate and compare the flexural strength of heated polymerized acrylic res...

Flexible composite films were produced by impregnating aqueous phenol formaldehyde (PF) resin into water-swollen cellulose nanofibril (CNF) films. CNF films were prepared using a pressurized filtration method in combination with freeze drying. The freeze-dried films were swollen with water then impregnated with PF resin by soaking in aqueous resin solutions of varying concentrations. Small amou...

Background and Aim: The aim of the present study was to investigate adhesion ability of resin-modified glass ionomer adhesive (Vitrebond) to ethanol-saturated dentin following two different surface conditioning regimes in term of microtensile bond

Basalt fiber-reinforced polymer (BFRP) composites are receiving increasing attention as they represent a low-cost green source of raw materials. FRP composites have to face harsh environments, such as chloride ions in coastal marine environments or cold regions with salt deicing. The resistance of FRPs subjected to the above environments is critical for the safe design and application of BFRP c...

background and aims. polymethyl methacrylate, pmma, is widely used in prosthodontics for fabrication of removable prostheses. this study was undertaken to investigate the effect of adding silver nanoparticles (agnps) to pmma at 2% and 0.2% concentrations on compressive and tensile strengths of pmma. materials and methods. the silver nanoparticles were mixed with heat-cured acrylic resin in an a...