This paper presents an investigation of the interface quality of nanocristallised 316L stainless steel multilayer structures. They were produced by a duplex process, combining the Surface Mechanical Attrition Treatment (SMAT) and the co-rolling process at two different annealing temperatures (550°C and 650°C). Oxide layers were observed at the interfaces between the sheets and their morphology ...

One of the major aims of the modern materials foundry industry is the achievement of advanced mechanical properties of metals, especially of light non-ferrous alloys such as aluminum. Usually an alloying process is applied to obtain the required properties of aluminum alloys. However, the presented work describes an alternative approach through the application of vibration treatment, modificati...

To overcome the trade-off between strength and ductility of additively manufactured AlSi10Mg alloy used in automotive aerospace industries, samples with multilevel structural heterogeneities were produced using single-pass ECAP at 150 °C 200 °C. The microstructures these composed partially ruptured Al/Si cellular networks alternatively arranged zones elongated (pancaked) grains separated by wid...

This study is aimed to optimize the tensile properties and fracture toughness of rapidly solidified (RS) ribbon-consolidated Mg–0.85Zn–2.05Y–0.35Al (at%) alloys by changing pre-consolidation heat-treatment temperature. The prepared from RS ribbons heat-treated below 673 K consisting bimodal ?-Mg grains; coarse-worked grains (?2.8 µm) with high Kernel average misorientation (KAM) values (?1.8°),...

Cell disruption is an important step during the extraction of C-phycocyanin from Spirulina platensis. An ultrafine shearing method is introduced and combined with soaking and ultrasonication to disrupt the cell walls of S. platensis efficiently and economically. Five kinds of cell disruption method, including soaking, ultrasonication, freezing-thawing, soaking-ultrafine shearing and soaking-ult...

Motor vehicles in urban areas are the main source of ultrafine particles (diameters < 0.1 μm). Ultrafine particles are generally measured in terms of particle number because they have little mass and are prolific in terms of their numbers. These sized particles are of particular interest because of their ability to enter deep into the human respiratory system and contribute to negative health e...

this paper aims at investigating the influence of partial replacement of portland cement with ultrafine fillers compared to limestone powder on the durability and mechanical characteristics of concrete. for this purpose, ultrafine calcium carbonate materials with different specific surface areas of 9.7 and 15.1 m2/g and limestone powder (0.72 m2/g) were used. the results indicate that the ultra...

Two different aspects of the thermal stability of grains were studied – (i) thermal stability of grain structure evolution during friction stir processing (FSP), and (ii) thermal stability of grains after FSP. It was concluded that Al3(Sc,Zr) dispersoids are effective in limiting grain growth to ultrafine grained regime (UFG) by stabilizing the microstructure during FSP. The presence of these d...