In this work, two different approaches – an iterative thermodynamic method and a neural network model – are proposed and compared for the modeling of steam turbines. The iterative thermodynamic model can predict steam mass flow, pressure, temperature, enthalpy and power on each turbine drum. The NN model can predict the generated mechanical power. Both models have been trained and validated on ...

The optimal design of a plate-fin recuperator of a 200-kW microturbine was studied in this paper. The exergy efficiency, pressure drop and total cost were selected as the three important objective functions of the recuperator. Genetic Algorithm (GA) and Non-dominated Sorting Genetic Algorithm (NSGA-II) were respectively employed for single-objective and multi-objective optimizations. By opt...

A design point simulation and adaptation of anindustrial GE LM2500+ gas turbine engine is presented. The design point is chosen when the engine runs steadily at operating point and close to the nominal design condition at 29MW power output. The targeted performance parameters are the fuel flow rate (FF), the compressor exit total pressure (P3), the compressor turbine total exit temperature (T8)...

In this study, for the first time, the heat transfer and the pressure drop of zinc oxide nanoparticles in alternating elliptical axis (AEA) tube have been investigated experimentally. The zinc oxide nanoparticles were at volumetric concentrations 1% and 2%. The base fluid was heat transfer oil and the experiments were conducted at constant wall temperature. Also, the study was done in Reynolds ...

A new mechanism responsible for structural life consumption due to resonant fatigue in turbine blades, or vanes, is presented and explained. A rotating blade or vane in a gas turbine can change its contour due to erosion and/or material build up, in any of these instances, the surface pressure distribution occurring on the suction and pressure sides of blades-vanes can suffer substantial modifi...

We have developed a new wind turbine system that consists of a diffuser shroud with a broad-ring brim at the exit periphery and a wind turbine inside it. The shrouded wind turbine with a brimmed diffuser has demonstrated power augmentation by a factor of about 2–5 compared with a bare wind turbine, for a given turbine diameter and wind speed. This is because a low-pressure region, due to a stro...

In this study thermodynamic performance analysis of a combined organic Rankine cycle and ejector refrigeration cycle is carried out for use of low-grade heat source in the form of sensible energy. Special attention is paid to the effects of system parameters including the turbine inlet temperature and turbine inlet pressure on the characteristics of the system such as ratios of mass flow rate, ...

in high-pressure axial turbines, when the fluid mass flow is low, the supersonic blades are being used to obtain a high specific work output. to prevent losses due to low blade aspect ratio, the turbine is used in partial admission conditions. the turbine stator is a group of convergence-divergence nozzles that provides the supersonic flow. the design of these nozzles is important, because ther...

    Given the need to increase the efficiency of heat transfer in thermal systems, especially systems using nanofluids in microscale and nanoscale heat transfer equipment ideas to improve their performance is very good.In present study, the flow and heat transfer of Water-Cu nanofluid in micro-tube with slip regime with constant wall heat flux numerically simulated with low Reynolds numbers. Sl...