This paper presents the analysin ,design and implementation of a high voltage ratio topology of DC-DC converter. The DC-DC converter has high voltage ratio with reduced input current, output voltage and output current ripple, and also reduces the voltage and current rating of power electronics components and compared with conventional boost converter. The voltage stress on the switches are  red...

In this paper, a two-stage AC/DC converter is presented for a low-profile laptop adaptor. The system consists of a boost power factor pre-regulator and LLC resonant converter. The pre-regulator features high PF and high-efficiency, while secondary LLC converter features zero voltage switching (ZVS). The transformer in LLC converter is splited in two to reduce current stress and converter height...

A soft-switching topology for high power buck converter is proposed. Zero-current turn-on and zero-voltage turn-off is achieved without auxiliary switches. All active switches in the converter transmit power to the load equally. Converter control is simple despite four active switches. Converter operation is described and DC analysis is carried out. All operation modes are identified. The condi...

In this paper, a multiphase boost converter is proposed to achieve high voltage gain and high power gain. The proposed converter operates in continuous conduction mode (CCM) with soft switching of main and auxiliary devices. The transformer in a conventional converter is replaced by an auxiliary circuit which provides the desired voltage and power levels. The zero voltage switching (ZVS) and ze...

This article shows the proposal of a linear–assisted converter or linear–&–switching hybrid converter with a constant switching frequency. The control loop of the system is based on the current–mode technique. The main disadvantage of a converter with current–mode control is the inherent instability of the loop when switch duty ratios are greater than 0.5. In order to make stable the proposed l...

The existence of unreliable renewable energy resources would be required to use energy resources and storage units simultaneously, particularly in applications such as electrical vehicles and stand-alone energy supplying systems. The objective of this paper is to introduce a new topology of multi input converter in hybrid power supply system of photovoltaic, fuel cell and battery for medium pow...

In this paper, in order to achieve zero ripple conditions, the use of a ripple mirror (RM) circuit for the boost converter is proposed. The operation modes are studied and steady-state analyses performed to show the merits of the proposed converter. It is found that the proposed RM circuit technique can provide much better flexibility than the two-phase interleaved boost converter for locating ...

This Paper presents the application of Single Phase Matrix converter as a Cycloconverter and Cycloinverter. Sinusoidal Pulse Width Modulation (SPWM) technique is used to generate control pulses for the Matrix Converter switches to produce output. The switching sequences for the Matrix Converter to operate as Cycloconverter and Cycloinverter are presented and evaluated using MATLAB/ Simulink. Th...

Implemented 5-bit 125-MS/s successive approximation register (SAR) analog to digital converter (ADC) on FPGA is presented in this paper.The design and modeling of a high performance SAR analog to digital converter are based on monotonic capacitor switching procedure algorithm .Spartan 3 FPGA is chosen for implementing SAR analog to digital converter algorithm. SAR VHDL program writes in Xilinx ...

This paper presents implementations of a nonisolated, high voltage gain DC-DC converter. High voltage gain is achieved due to inclusion of resonance and transformer in the circuit. The performance of this converter is compared with two similar topologies namely coupled inductor-switched capacitor step-up converter and coupled inductor step-up converter. The proposed prototype is designed using ...