in this paper, the combined effect of suspended (fine dust) particles and rotation on the onset of thermosolutal convection in an elastico-viscous fluid in a porous medium is studied. for the porous medium, the brinkman model is employed and rivlin-ericksen model is used to characterize viscoelastic fluid. by applying normal mode analysis method, the dispersion relation has been derived and sol...

In this paper, a comprehensive numerical study is presented for studying the MHD flow and heat transfer characteristics of non-Newtonian micropolar fluid through a porous medium between two stretchable porous disks. The system of governing equations is converted into coupled nonlinear ordinary ones through a similarity transformation, which is then solved using Quasi-linearization ...

We analyze the thermal convection thresholds and linear characteristics of the primary 1 and secondary instabilities for viscoelastic fluids saturating a porous horizontal layer heated from 2 below by a constant flux. Galerkin method is used to solve the eigenvalue problem by taking 3 into account the elasticity of the fluid, the ratio between the viscosity of the solvent and the total 4 viscos...

Single-walled carbon nanotube bundles dispersed in a highly polar fluid are found to agglomerate into a porous structure when exposed to low levels of laser radiation. The phototunable nanoscale porous structures provide an unusual way to control the acoustic properties of the suspension. Despite the high sound speed of the nanotubes, the measured speed of longitudinal-acoustic waves in the sus...

B ioreactors allowing direct perfusion of culture medium through tissue-engineered constructs may overcome diffusion limitations associated with static culturing, and may provide flow-mediated mechanical stimuli. The hydrodynamic stress imposed on cells in these systems will depend not only on the culture medium flow rate but also on the scaffold three dimensional (3D) micro-architecture. We pe...

Bioreactors allowing direct perfusion of culture medium through tissueengineered constructs may overcome diffusion limitations associated with static culturing, and may provide flow-mediated mechanical stimuli. The hydrodynamic stress imposed on cells in these systems will depend not only on the culture medium flow rate but also on the scaffold three-dimensional (3D) micro-architecture. We perf...

In this work, porous nanoparticles of ferrite cobalt were prepared by dissolving CoCl2.6H2O and FeCl3 in ethylene glycol in a hydrothermal process. Using ethylene glycol instead of DI water as a solvent would cause to provide porous structure of ferrite cobalt. 0.05 ml of colloidal fluid of fabricated nanostructure was injected on interdigitated electrodes (IDE) on a printed circuit board (PCB)...

We present a numerical solution of the natural convection from inclined wall plumes which arise from a line thermal source imbedded at the leading edge of an adiabatic plate with arbitrary tilt angle between 0 and n/2, and embedded in a fluid-saturated porous medium. An appropriate transformation of the governing boundary-layer equations is proposed and a very efficient novel numerical solution...

This paper presents a new approach to study the effects of temperature on the poroelastic and viscoelastic behavior of articular cartilage. Biphasic solid-fluid mixture theory is applied to study the poro-mechancial behavior of articular cartilage in a fully saturated state. The balance of linear momentum, mass, and energy are considered to describe deformation of the solid skeleton, pore fluid...

The emergence of structure in reactive geofluid systems is of current interest. In geofluid systems, the fluids are supported by a porous medium whose physical and chemical properties may vary in space and time, sometimes sharply, and which may also evolve in reaction with the local fluids. Geofluids may also experience pressure and temperature conditions within the porous medium that drive the...