Memristors are used to compare three gathering techniques in an already-mapped environment where resource locations are known. The All Site model, which apportions gatherers based on the modeled memristance of that path, proves to be good at increasing overall efficiency and decreasing time to fully deplete an environment, however it only works well when the resources are of similar quality. Th...

In this paper, a generic uniform scallop tool path generation method for five-axis machining is presented. Unlike the conventionalmethodswhich are based on the local surface geometry assumptions, thismethod is inspired by cutting simulation. Initially, the designed surface is planted with dense grasses. If a cutter is put onto the surface, the affected grasses will be cut short. All the affecte...

Computer-Aided Manufacturing (CAM) occupies an increasingly important role in engineering with all it has to offer in terms of new possibilities and improving designer/manufacturer productivity. The present study addresses machining of free-form surfaces on a 3-axis NCmachine tool. There have recently been a large number of studies devoted to planning tool paths on free-form surfaceswith variou...

Carbon fiber reinforced plastics (CFRP) have good physical properties, such as high specific strength and high specific modulus. However, cutting delamination, tearing and burr, etc. often occur in the machining process of CFRP, which results in the uncontrollability of machining surface quality and serious tool wear. In this paper, milling of CFRP with a staggered cutter was carried out, the c...

It is occasionally difficult to disconnect leads from headers at the time of pulse generator replacement without injuring the fragile leads. Over a 2.5-year period we encountered this problem in six cases (1.7% of pulse generator replacements). The posterior portion of the header was clipped off using an orthopedic bone cutter in four cases. The cut was aligned with the deep end of the lead soc...

Recently, use of parallel turning operations has been increasing due to the potential they offer for improved material removal rate using multiple cutting tools. However, chatter vibrations resulting from process instability may limit the productivity in these operations. In order to determine favourable conditions for increased stability, dynamics of parallel turning operations must be modelle...

Abstract: This paper applied the concept of “contact” in Differential Geometry into the machining of the sculptured surface. I presented the contact principle of the machining of complicated surfaces, using the circumference circle of the cylindrical cutter to sweep the curved surface instead of ball-end mill. This is highly effective method. In this paper an theory for machining complicated su...

Restriction map polymorphism in a 13-kb region of the Zw locus in Drosophila melanogaster was investigated for 64 X chromosome lines with seven 6-cutter and ten 4-cutter restriction enzymes. A total of 203 restriction sites were scored, of which 20 were found to be polymorphic. The estimated nucleotide variation for this region for overall data (pi = 0.003 and 0.001, and theta = 0.003 and 0.002...

An attachable electromagnetic-energy-harvester driven wireless vibration-sensing system for monitoring milling-processes and cutter-wear/breakage-conditions is demonstrated. The system includes an electromagnetic energy harvester, three single-axis Micro Electro-Mechanical Systems (MEMS) accelerometers, a wireless chip module, and corresponding circuits. The harvester consisting of magnets with...

We study the problem of finding shortest tours/paths for “lawn mowing” and “milling” problems: Given a region in the plane, and given the shape of a “cutter” (typically, a circle or a square), find a shortest tour/path for the cutter such that every point within the region is covered by the cutter at some position along the tour/path. In the milling version of the problem, the cutter is constra...