Weighted Uniform Simulation (WUS) is recently presented as one of the efficient simulation methods to obtain structural failure probability and most probable point (MPP). This method requires initial assumptions of failure probability to obtain results. Besides, it has the problem of variation in results when it conducted with few samples. In the present study three strategies have been present...

ABR will be one of the primary available ATM service for carrying data. Since it is based on the use of excess bandwidth in the network, it is expected to have a lower cost usage. Although, it is intended for nonreal time applications, the inclusion of a minimum cell rate (MCR) makes it an attractive and economical candidate for the transmission of delay tolerant video applications. Therefore, ...

Simulation of a process and analysis of its resulting data in both dynamic and steady-state conditions are fundamental steps in understanding the process in order to design and efficient control of system as well as implementing operational cost reduction scheme. In the present paper, steady and unsteady state simulation of Amir Kabir1, 3 butadiene purification units has been done by using Aspe...

Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...

many simulation algorithms (chemical reaction systems, differential systems arising from the modeling of transient behavior in the process industries and etc.) contain the numerical solution of systems of differential equations. for the efficient solution of the above mentioned problems, linear multistep methods or runge-kutta technique are used. for the simulation of chemical procedures the ra...