Aim. To investigate the effect of C factor on marginal adaptation of low-shrinking composite (Silorane).The null hypothesis was that the marginal adaptation of "Silorane" is not affected by the cavity configuration. Materials and Methods. A Silorane based and a methacrylate based composites, with their corresponding self-etch adhesive systems "Filtek Silorane/Silorane Adhesive Bond System and F...

Introduction – Shrinkage during polymerization of resin-based composite materials may lead to gap formation and hamper the marginal adaptation of the restorations. To reduce the problem of polymerization shrinkage, a new composite material (FiltekTM Silorane, 3M-ESPE, Germany), with a reduced shrinkage, has been marketed. Objective – To investigate whether reduced polymerization shrinkage impro...

Purpose. This study tested the null hypothesis that different classes of direct restorative dental materials: silorane-based resin, low-shrinkage and conventional (non-flowable and flowable) resin-based composite (RBC) do not differ from each other with regard to polymerization shrinkage, depth of cure or microhardness. Methods. 140 RBC samples were fabricated and tested by one calibrated opera...

OBJECTIVES This study examined the influence of the resin thickness on the polymerization of silorane- and methacrylate-based composites. MATERIALS AND METHODS One silorane-based (Filtek P90, 3M ESPE) and two methacrylate-based (Filtek Z250 and Z350, 3M ESPE) composite resins were used. The number of photons were detected using a photodiode detector at the different thicknesses (thickness, 1,...

OBJECTIVES Light-curing of resin-based materials (RBMs) increases the pulp chamber temperature, with detrimental effects on the vital pulp. This in vitro study compared the temperature rise under demineralized human tooth dentin during light-curing and the degrees of conversion (DCs) of three different RBMs using quartz tungsten halogen (QTH) and light-emitting diode (LED) units (LCUs). MATER...

background: the current study evaluated the micro‑shear bond strengths of a new low‑shrinkage composite resin to dentin. materials and methods: in this in‑vitro study, 70 extracted premolars were assigned to one of seven groups ( n = 10): group 1: optibond solo plus (opt; kerr); group 2: se bond (se; kuraray); group 3: silorane system adhesive (ssa; 3m espe); group 4: optibond solo plus + ls bo...

BACKGROUND Moisture control is very important in restorative procedures in dentistry. Use of hemostatic agents helps control moisture; however, they might result in changes on enamel and dentin surfaces, affecting composite resin bond quality. The aim of this in vitro study was to evaluate the marginal microleakage of two different composite resins with the use of three different hemostatic age...

The aim of this study was to investigate the influence of different composite resins - Filtek P90 (silorane-based composite) and Heliomolar (methacrylate-based composite) - on light transmission and decrease in Knoop hardness between the bottom and top of cured specimens. The irradiance of a light-curing unit (LCU) was measured with a power meter (Ophir Optronics; 900 mw/cm2) and spectral distr...