-We present a photorefractively pumped ring resonator for the formation of self-organized, topology-preserving mappings. The self-imaging ring resonator with saturable gain and loss supports localized cavity modes at arbitrary transverse locations. When the resonator is pumped by two uncorrelated signals, two spatially well separated modes form. Each mode is correlated temporally with one of th...

In this paper novel reflectarray antenna elements are proposed using aperture-coupled dielectric resonator antenna structures. Using these new structures, wide phase range and wide frequency bandwidth (up to 28.5%) with parallel and linear phase curves are obtained. In each case, an array consisting of 289 elements was simulated using the finite integration technique (FIT). The arrays exhibit 3...

We demonstrate a large-scale tunable-coupling ring resonator array, suitable for high-dimensional classical and quantum transforms, in a CMOS-compatible silicon photonics platform. The device consists of a waveguide coupled to 15 ring-based dispersive elements with programmable linewidths and resonance frequencies. The ability to control both quality factor and frequency of each ring provides a...

We present the design of 3-D metamaterial stacked arrays for efficient conversion of electromagnetic waves energy into AC. The design consists of several vertically stacked arrays where each array is comprised of multiple Split-Ring Resonators. The achieved conversion efficiency is validated by calculating the power dissipated in a resistive load connected across the gap of each resonator. Nume...

Introduction: Frequency selective surfaces (FSS) are based on metallic resonator arrays with tailored transmittance and reflectivity properties [I]. Recently, it has been proposed in a numerical study to use THzFSS based on asymmetric split ring resonators as a sensor for detecting biomolecular sample films with a thickness of only 10 nm [2]. Because large biomolecules, e.g. DNA, exhibit a mult...

In this design an optical ring resonator are embedded between two Horizontal input and output waveguides which has 4 orbitals around the center of the resonator so that each orbital consists of 8 rods with different size in which radius of larger orbitals rods are bigger than radius of smaller orbitals rods. The analysis of simulation results showed the proposed filter has the transmission effi...

In this paper, we propose an angle- and polarization-insensitive metamaterial absorber. We design a metamaterial unit cell that is based on a split ring cross resonator (SRCR). We observe that the absorption frequency and absorption ratio are insensitive to incident angles when a via array surrounds the SRR. We demonstrate the effect of the via array using full-wave simulations by comparing the...

Ring resonators have always been referred to as a highly flexible structurefor designing optical devices. In this study, we have designed and simulation a fourchannel optical demultiplexer using square photonic crystal ring resonator. The squarelattice constant for this purpose structure is used. The purposed structure has an averagecrosstalk, transmission coefficient, q...