Cell adhesion, migration, and proliferation are significantly affected by the surface topography of the substrates on which the cells are cultured. Alumina is one of the most popular implant materials used in orthopedics, but few data are available concerning the cellular responses of mesenchymal stem cells (MSCs) grown on nanoporous structures. MSCs were cultured on smooth alumina substrates a...

We report the fabrication of thermoelectric bismuth teUuride nanowires using the template synthesis method. A simple electrodeposition procedure was used to produce the nanowires within the pores of an alumina filtration membrane. The resulting bismuth telluride/alumina composite membranes constitute an array of thermoelectric nanowires surrounded by a thermally and electrically insulating matr...

We present here the behavior of the resonance frequency of porous anodic alumina cantilever arrays during water vapor adsorption and emphasize their possible use in the micromechanical sensing of humidity levels at least in the range of 10-22%. The sensitivity of porous anodic aluminium oxide cantilevers (Δf/Δm) and the humidity sensitivity equal about 56 Hz/pg and about 100 Hz/%, respectively....

The synthesis of a conformal three-dimensional nanostructure based on porous anodic alumina with transversal nanopores on wires is herein presented. The resulting three-dimensional network exhibits the same nanostructure as that obtained on planar geometries, but with a macroscopic cylindrical geometry. The morphological analysis of the nanostructure revealed the effects of the initial defects ...

a water–soluble gelatin combined with polyethylene microspheres were developed to prepare alumina composite foam. gelatin was used as the gelling agent and polyethylene was used as pore making template. on the other hand, kaolin was used to provide green strength and cuo was applied to decrease the required temperature as a sinter aid. alumina bodies need elevate temperature for sintering, incr...

In this study porous alumina samples were prepared and then coated using the biomimetic coating technique using a five times Simulated Body Fluid (5.0SBF) as the growth solution. A coating was achieved after pre-treatment with concentrated acid. From elemental analysis, the coating contained calcium and phosphorous, but also sodium and chlorine. Halite was identified by XRD, a sodium chloride p...

The objectives of this study were to analyse the effect of inkjet 3-D printing parameters, particularly the splat overlap distance, for the fabrication of defect-free porous Al2O3 ceramic multilayers, and to correlate the resulting porosities with the mechanical properties measured using nanoindentation. An aqua-based alumina ink was used in this study to fabricate the multilayers on dense alum...