in this research, the effect of wood species and particle size on mechanicalproperties of wood plastic composites (wpc) made of fir (abies alba) and beech(fagus orientalis l.) sawdust and high density polyethylene (hdpe) wereinvestigated. wood plastic composite (wpc) were made with 30% hdpe in abatch process at 185˚c, at two particle sizes of 40 mesh and 80 mesh. maleicanhydride polypropylene (...

Nine urban intertidal regions in Burrard Inlet, Vancouver, British Columbia, Canada, were sampled for plastic debris. Debris included macro and micro plastics and originated from a wide diversity of uses ranging from personal hygiene to solar cells. Debris was characterized for its polymer through standard physiochemical characteristics, then subject to a weak acid extraction to remove the meta...

Plasma treatment of particles offers to tailor macroscopic powder properties like wettability, flowability or compactibility. Plasma activation normally leads to an enhanced wettability and the deposition of SiOx-like nanostructures on the substrate particle surface increases the flowability and compactibility. These different functionalities are investigated and compared for the polymer HDPE (...

Organic compounds such as benzene, toluene, ethyl benzene and o-, m-, and p-xylene from contaminated soil and groundwater may permeate through thermoplastic pipes which are used for the conveyance of drinking water in water distribution systems. In this study, permeation parameters of benzene in 25 mm (1 inch) standard inside dimension ratio (SIDR) 9 high density polyethylene (HDPE) pipes were ...

In this research, the effect of wood species and particle size on mechanicalproperties of wood plastic composites (WPC) made of fir (Abies alba) and beech(Fagus orientalis L.) sawdust and high density polyethylene (HDPE) wereinvestigated. Wood plastic composite (WPC) were made with 30% HDPE in abatch process at 185˚C, at two particle sizes of 40 mesh and 80 mesh. Maleicanhydride polypropylene (...

Cross linking of high density polyethylene (HDPE) was first performed via high energy10 Mev electron beam (EB) irradiation. HDPE was also cross linked withDicumyle peroxide (DCP).The gel content of samples was determined by solvent extraction.Degree of cross linking was evaluated by hot set apparatus; as well .In order to clarify the effectof nature of cross linking, correlation of electrical p...

In this study, blends based on a high density polyethylene (HDPE) and chitosan (CS) were successfully prepared by melt processing, in a laboratory internal mixer. The CS biopolymer content effect (up to maximum of 40%), and, the addition of bentonite clay modified with quaternary ammonium salt (CTAB) impregnated chitosan as a compatibilizing agent, on the properties of the blends was analyzed b...

The objective of this study was to examine the effects of the hydroxyapatite (HA) reinforcement morphology and content on the fatigue behavior of HA reinforced high density polyethylene (HDPE). To this end, HDPE was reinforced with 20 and 40 vol% of either HA whiskers or an equiaxed HA powder, and tested in four-point bending fatigue under simulated physiological conditions. The fatigue life, m...

The development of value-added products made from post-consumer plastic recyclates has become an important goal in the quest for a sustainable society. To attain such goal, tools with higher accuracy and wider scope are increasingly necessary. The present work describes the application of a Life Cycle Assessment (LCA)/Life Cycle Costing (LCC) integrated model, with inclusion of externalities (e...

Producing both hydrogen and high-value carbon nanotubes (CNTs) derived from waste plastics is reported here using a pyrolysis-reforming technology comprising a two-stage reaction system, in the presence of steam and a Ni-Mn-Al catalyst. The waste plastics consisted of plastics from a motor oil container (MOC), commercial waste high density polyethylene (HDPE) and regranulated HDPE waste contain...