Aim: The study evaluated the efficiency of various finishing and polishing systems and the effect of finishing and polishing time by using various procedures on surface roughness and hardness of silorane based (FiltekP90) and methacrylate based (Z100) restorative materials. Method: The surface roughness and surface hardness were measured using a profilometer and Vickers hardness tester respecti...

Diamond is one of the hardest and most difficult to polish materials. In this paper, the polishing of {111} and {100} single crystal diamond surfaces by standard chemical mechanical polishing, as used in the silicon industry, is demonstrated. A Logitech Tribo Chemical Mechanical Polishing system with Logitech SF1 Syton and a polyurethane/polyester polishing pad was used. A reduction in roughnes...

Through the polishing experiments of potassium dihydrogen phosphate (KDP) crystals based on deliquescent action, the effect of several major factors, including crystal's initial surface state, polishing time, and revolution of polishing plate, on material removal was researched. Under certain experimental conditions, the rules of material removal were reached, and experimental results are discu...

In this article, a furniture polishing robot, which uses a trajectory generator based on cutter location data, is proposed. The position and orientation of the polishing tool is suitably controlled by referring the output from the trajectory generator. The trajectory generator yields a zigzag path, whirl path or their combinational path according to the shape of each workpiece. Using the trajec...

Surface smoothness is one of the properties determining the performance of stents. Therefore, surface polishing shows its importance in the exploitation and production of stents. The present study explores electrochemical polishing of 316L stainless steel slotted tube coronary stents produced by laser cutting. Acid pickling was also studied as a pre-treatment of electrochemical polishing of the...

This study examined the average surface roughness (Ra, microm) of 2 microfilled (Durafill and Perfection), 1 hybrid (Filtek Z250) and 2 packable composite resins (Surefil and Fill Magic), before (baseline) and after eight different finishing and polishing treatments. The surface roughness was assessed using a profilometer. Ten specimens of each composite resin were randomly subjected to one of ...

The purpose of this investigation was to measure and compare both the surface roughness and gloss of flowable composites polished with standardized silicone carbide (SiC) papers. Four flowable and two conventional composites were used in this study. Polymerized specimens were subjected to a polishing procedure comprising 12 sequential steps from coarser to finer grits of SiC paper. At the initi...

OBJECTIVES To investigate the surface properties (roughness, composition, phase transformation) of monolithic zirconia specimens after dental adjustment procedures (grinding, polishing) and wear simulation. METHODS Zirconia specimens (Cercon base, Cercon ht, DeguDent, G; n=10/material) were successively sintered, ground, and polished with an intraoral polishing kit in a three-step procedure. ...

The finishing process of advanced ceramic balls can be divided into two steps. The first step is lapping in which most of the stock from the ball is removed at a higher material removal rate. The second step is polishing in which the required ball surface roughness, roundness, dimensional and geometric accuracy are achieved. In polishing, the abrasive particle size is ≤ 1 μm, and the load and s...