This study reports the development of high efficiency polishing protocols of fibre connectors, by replacing the presents three step polishing with two step polishing protocols, and by using various abrasives as polishing mediums, to achieve necessary geometrical and optical qualities for physical contact transmission using a commercially available connector polisher. The study focuses on surfac...

A novel fibre optic sensing system with a high time resolution of less than 0.04 ps based on an optical pulse correlation measurement mechanism and differential detection technique is investigated. The optical pulse correlation state corresponding to time drift in fibre optic transmission lines is detected by SHG. The results of temperature and strain sensing experiments demonstrate an excellen...

Optimised compression of femtosecond fibre laser pulses in highly nonlinear fibre is demonstrated. Specifically reported are compressed pulse durations below 30 fs using a simple setup where a single sub10 cm segment of highly nonlinear fibre is directly spliced to the output pigtail of a commercial femtosecond fibre laser. The compressed pulse quality is confirmed through frequency resolved op...

Single optical fibres exhibiting minimum dispersion over the two optical wavelength windows of 1300 and 1550 nm region are essential for the multi-channel operation of dense wavelength multiplexed systems and networks. Design guidelines of dispersion-flattened optical fibres, over a wide band of optical spectrum, which have a triple-clad or segmented-core distribution of stepindex regions are d...

An optical fibre sensor for simultaneous temperature and humidity measurements consisting of one fibre Bragg grating (FBG) to measure temperature and a mesoporous film of bilayers of Poly(allylamine hydrochloride)(PAH) and silica (SiO2) nanoparticles deposited onto the tip of the same fibre to measure humidity is reported. The hygroscopic film was created using the layer-by-layer (LbL) method a...

Distributed optical fibre sensing, employing either Rayleigh, Raman, or Brillouin scattering, is the only physical-contact sensor technology capable of accurately estimating physical fields with spatial continuity along the fibre. This unique feature and the other features of standard optical fibre sensors (e.g., minimal invasiveness and lightweight, remote powering/interrogating capabilities) ...

By controlling the fibre geometry, the fraction of optical field within the holes and the inserted material of a photonic crystal fibre, we demonstrate that it is possible to engineer any arbitrary wavelength-dependent thermo-optic coefficient. The possibility of making a fibre with a zero temperature dependent thermo-optic coefficient, ideal for packaging of structured fibre gratings, is propo...

Most of the digital data transmitted are carried by optical fibres, forming the great part of the national and international communication infrastructure. The information-carrying capacity of these networks has increased vastly over the past decades through the introduction of wavelength division multiplexing, advanced modulation formats, digital signal processing and improved optical fibre and...

We have reported the thermoluminescence (TL) response of five different diameters ~120, 241, 362, 483, and 604 μm of 6 mol percent Ge-doped optical fibres. The perfomance of the Ge-doped optical fibre are compared with commercially available TLD-100 chips (LiF:Mg,Ti) in terms of their sensitivity and minimum detectable dose (MDD). The irradiation was performed using X-ray machine (Model ISO ‘Na...

In this paper we have discussed a simulated long haul optical transmission system Over the single mode fibre which is prove to the liner chromatic dispersion as well as Non linearity. Both Parameter have been of great concern as these confine the overall Efficiency of the system. Loop control is commonly chosen as an important component in optical communication system. Loop control is very simp...