Natural hazards such as earthquakes have threatened the life of human beings during the history.As a consequence, the vibration mitigation of structures has caught great importance. Activecontrol of structures is one of the rapidly emerging areas in the concept of structural control. Thispaper presents a control method to deal with this subject when the dynamics of the structure ishysteretic an...

Reliable measurements of ball mill load parameters and reorganization of the operating statuses are the key factors for saving energy and optimization control. Empirical mode decomposition (EMD) and partial least squares (PLS) are used to analyze shell vibration signal and monitor mill load parameters of ball mill. The shell vibration signal is decomposed into several intrinsic mode functions (...

Reciprocating diaphragm micro-pumps are the most common type among indirectly–driven micro-pumps. They operate by reciprocating the diaphragm with associated check valves. This paper addresses the Hydroelastic vibration of circular elastic diaphragm interacting with the incompressible and inviscid liquid inside the cylindrical chamber with a central discharge opening. Taking into account axisym...

The aim of this paper is firstly to address the consequences of the nonlinear interactions between higher order modes and the first order mode of a flexible cantilever beam. The tested cantilever beam exhibited numerous nonlinear phenomena that are commonly observed in many flexible structures. The experimental results have shown that active control of the nonlinear vibration in a flexible stru...

One of the major problems in experimental vibration analysis is to determine location of transducers. It is important to place the transducers on locations with largest vibration amplitude and to avoid locations with zero-movement (nodal lines). These locations are best seen from vibration mode shapes. Finite element analysis (FEA) provides numerical values for natural frequencies, which are so...

In the present study, an experimental investigation was performed to characterize the vortex induced vibration (VIV) of a flexible cable in an oncoming shear flow. The VIV tests were conducted in a wind tunnel with a flexible cable model. It was found that, under different oncoming velocity profiles, the cable model behaved in single-mode and multi-mode VIVs. The displacement amplitudes of the ...

The ambient and forced vibration techniques for testing full-scale structures are critically compared. Both methods, based on small level excitation, may be used to determine many mode shapes and frequencies of vibration and the corresponding damping values, with adequate accuracy for most purposes. The two techniques give mutually consistent results. The mode amplitudes determined by ambient a...

in this paper, an optimal adaptive fuzzy integral sliding mode control is presented to control the robot manipulator position tracking in the presence of uncertainties and permanent magnet dc motor. in the proposed control, sliding surface of the sliding mode control is defined according to the information of position tracking error, derivatives, and error integral. in order to estimate bounds ...

This article presents the design and analysis of a novel dynamic stiffness tuning vibration absorber working with Magnetorheological elastomers (MRE). In this design, the MRE worked in a shear mode, but its MR effect was significantly enhanced by dynamically squeezing the sample thickness with an embedded piezoelectric (PZT) actuator. With this design, both the quasi-static magnetic field and t...

This paper reports the design and fabrication of capacitive silicon nanomechanical resonators with the selective vibration of a high-order mode. Fixed-fixed beam capacitive silicon resonators have been successfully produced by the use of electron beam lithography, photolithography, deep reactive ion etching, and anodic bonding methods. All resonators with different vibration modes are designed ...