BACKGROUND Enzymatic corn wet milling (E-milling) is a process derived from conventional wet milling for the recovery and purification of starch and co-products using proteases to eliminate the need for sulfites and decrease the steeping time. In 2006, the total starch production in USA by conventional wet milling equaled 23 billion kilograms, including modified starches and starches used for s...

Although Cu and Fe are immiscible under equilibrium conditions, they can form supersaturated solid solutions by mechanical alloying. In this paper, nano-structured of the metastable Cu-Fe phase containing 10, 15, 20 and 25% wt Fe were synthesized by intensive ball milling for 15h, in order to achieve a solid solution of Fe in Cu. The phase composition, dissolution of the Fe atoms into the Cu ma...

Mechanical alloying of binary and ternary elemental powder mixtures with the nominal compositions of Mg2Ni and Mg(2-x)MnxNi (x= 0, 0.05, 0.10 and 0.15 at. %) were carried out in a planetary ball mill for various milling times of 5, 10, 15, 20, 30 and 60 h. X-ray diffraction and field emission scanning and transmission electron microscopy were used for the characterization of the milled products...

Background: Enzymatic corn wet milling (E-milling) is a process derived from conventional wet milling for the recovery and purification of starch and co-products using proteases to eliminate the need for sulfites and decrease the steeping time. In 2006, the total starch production in USA by conventional wet milling equaled 23 billion kilograms, including modified starches and starches used for ...

This paper presents cutting force prediction algorithm for low immersion end-milling, using an efficient dynamic force modeler. The geometric simulation of milling process was performed, using the B-Rep solid modeling techniques. For predicting stability lobes, two methods were used for prediction of stability lobes: the frequency domain technique and the time finite element analysis (TFEA). Th...

The mechanochemical Knoevenagel condensation of malononitrile with p-nitrobenzaldehyde was studied in situ using a tandem approach. X-ray diffraction and Raman spectroscopy were combined to yield time-resolved information on the milling process. Under solvent-free conditions, the reaction leads to a quantitative conversion to p-nitrobenzylidenemalononitrile within 50 minutes. The in situ data i...

This paper proposes a novel chemo-mechanical method to in-situ functionalize carbon nanotubes (CNTs). Ball milling in the presence of ammonium bicarbonate allowed the introduction of amine and amide groups onto the surface of CNTs, resulting in the conversion of the semiconducting behavior of CNTs from p-type to n-type. The corresponding electrical conductivity of CNT increased gradually with b...

In this work, the strontium-doped lanthanum manganite- a ceramic material- used as cathode in solid oxide fuel cells. An impression of grinding time on the structural and thermal properties of Sr-doped LaMnO3 system with La1-xSrxMnO3 (x=0.2) stoichiometric ratio was investigated. The nano crystallite LSM powder with cubic structure was prepared by varying the milling time of planetary monomill ...

The influence of short-time milling on the atomic structure of amorphous Co(70.3)Fe(4.7)B(25) has been investigated by differential scanning calorimetry (DSC), x-ray powder diffraction (XRD), vibrating sample magnetometer (VSM) and x-ray absorption fine-structure (XAFS) techniques. Our results prove that the milling process crystallizes the initially amorphous sample and that the degree of inhe...

The time domain recursive least squares estimation of parameters in the presence of additive output noise of harmonic form leads to biased estimates. However, frequency domain least squares parameter estimation, where the frequency range contaminated by the noise is eliminated, can be used to obtain good parameter estimates. Both the time domain and frequency domain methods are described, and a...