Abstract Background Plastic materials have a significant impact on the entire environment. Very relevant ideas in different areas with aim of enhancing these and making them effective our daily lives. In this context, work article by using plastic manufacture hydrophobic membranes realized Laboratory LEEP Enig Gabes Tunisia, followed various analyses. These are made Recycled Low-Density Polyeth...

Nanoporous and single phase α-alumina membranes with pore diameters tunable over a wide range of approximately 60-350 nm were successfully fabricated by optimizing the conditions for anodizing, subsequent detachment, and heat treatment. The pore diameter increased and the cell diameter shrunk upon crystallization to α-alumina by approximately 20% and 3%, respectively, in accordance with the 23%...

Powder Injection Molding (PIM) is a precision manufacturing process used for production of advanced composites. Mixing of polymeric binder with metal powders, molding of feedstock, de-binding of brown parts and sintering of green samples are four main steps of this process. In the present study, the compounds containing multi-component binder system and aluminum/ nano-alumina (0-9 wt.%) powders...

We present recent experimental results of the use of electrostatic probes to characterize the differences seen in the low frequency instabilities (<200 kHz) in a laboratory Hall discharge operating with two very different wall materials alumina and boron nitride. A wavelet decomposition analysis of the probe signals was used to determine the dispersion and turbulent broadening characteristics, ...

the present study investigated the possibility of replacing salamon with modified shotor diluent (msd) and egg yolk (ey) with low density lipoprotein (ldl) for chilled storage of ram semen. good quality semen (>80% progressive forward motility (pfm) of sperm) from 3 fertile rams was collected using an artificial vagina and pooled for each experiment. low density lipoprotein was extracted from f...

9 = 0.6 I / s ' 7 = 6.0 0 7 = 2 4 i ti 3 = 6 0 Through close control over green-state powder processing, pure alumina ceramics of 0.5-pm grain size were obtained by sintering at 1250°C. The static grain growth of this material was modest at temperatures below 1300°C. However, dynamic grain growth occurred rapidly during superplastic deformation. Therefore, although the ultrafine-grained alumina...

MgAlON composites have been prepared under nitrogen atmosphere, using Dengfeng calcined alumina w(Al2O3) = 85 % and other raw material, in order to reduce the production cost and make full use of the rich bauxite resources in Henan Province. The effects of the different sintering temperature and different matrix content on the preparation and properties of MgAlON composites were investigated. T...

using the nanotechnology and decreasing the dimension of reinforcement particles to nanometer, outstanding mechanical properties are achieved in aluminum matrix nanocomposites. fabrication of aluminum matrix nanocomposites by casting is of great importance because of its simplicity, low cost and ease of the control of matrix microstructure. in this study, the aging behavior of nanocomposite sam...