This paper presents results obtained from the grinding of aluminium-based metal matrix composites reinforced with either aluminium oxide (Al2O3) or silicon carbide (SiC) particles using grinding wheels made of SiC in a vitrified matrix or diamond in a resin-bonded matrix. The study used grinding speeds of 1100–2200 m min , a grinding depth of 15 m for rough grinding and 0.1–1 m for fine grindin...

Study on ambient and cryogenic grinding was performed to test the novelty of cryogenic grinding and pin point the drawbacks of ambient grinding. Comparative study had shown that ambient grinding need more power (8.92%) and specific energy (14.5%) than cryogenic grinding. Particle size analysis had shown that cryogenic grinding produced coarser particles. Comparative study of energy law constant...

this study investigates the influence of some chemical additives such as methanol, ethanol, sodium oleat, chloroform and sodium hexametaphosphate (shmp) on the dry fine grinding of calcite (x50= 33 µm) using a stirred media mill. the experiments were carried out by a batch operation, and the change in colour properties (ry, whiteness and yellowness) of calcite powder. the results showed that th...

This study investigates the grinding of sintered silicon nitride using a SiC wheel with a fine abrasive grit size and dense vitreous bond. The difference of hardness between the green SiC abrasive and sintered Si3N4 workpiece (25.5 vs. 13.7 GPa) is small. Large grinding forces, particularly the specific tangential grinding forces, are observed in SiC grinding of Si3N4. The measured specific gri...

The grinding is one of the most important methods that directly affects tolerances in dimensions, quality and finished surface of products. One of the major problems in the material removal processes specially grinding is the heat generation during the process and the residual tensile stress in the surfaces of product. Therefore, optimization of High Efficiency Deep Grinding (HEDG) process is t...

Conventional material removal of BK7 optical glass will normally result in brittle fracture at the surface, generating severe subsurface damage and poor surface finish. Subsurface damages induced by grinding strongly influence the mechanical strength and optical quality of optical glasses. However, through ductile mode grinding it is possible to reduce the surface and subsurface cracks. It is m...

Introduction When the grinding wheel specifications are properly chosen, a SiC grinding wheel performs remarkably well for grinding partially stabilized MgO-ZrO2 ceramics (MgO-PSZ). Rather surprisingly, the highest Gratios are obtained at higher grinding rates for the SiC wheel. This, and the fact that SiC grinding wheels can be readily shaped for use in precision cylindrical form grinding, has...

Conventional material removal of BK7 optical glass will normally result in brittle fracture at the surface, generating severe subsurface damage and poor surface finish. Subsurface damages induced by grinding strongly influence the mechanical strength and optical quality of optical glasses. However, through ductile mode grinding it is possible to reduce the surface and subsurface cracks. It is m...

Porous silicon samples were prepared by electrochemical etching method for different etching times. The structural properties of porous silicon (PS) samples were determined from the Atomic Force Microscopy (AFM) measurements. The surface mean root square roughness (σ rms) changes as function of porosity were studied, and the influence of etching time on porosity and roughness was studied too. U...