A novel approach for bulk synthesis of lithium-intercalated graphene sheets through the reduction of exfoliated graphene oxide in liquid ammonia and lithium metal is reported. It is demonstrated here that as-synthesized lithiated graphite oxide sheets (Li-RGO) can be directly used as an electrode material in lithium batteries. The electrochemical studies on Li-RGO electrodes show a significant ...

The electrical properties of graphite oxide (GO) can be tuned consecutively by treating samples with ammonia and hydrogen plasma. When altering ammonia plasma time from 10 to 4.5 min, large area (greater than 100×100 μm²), n-type, ambipolar and p-type semiconducting reduced graphite oxide (RGO) sheets could be obtained. The highest mobilities of the electron and hole are 5.41 and 2.10 cm² V⁻¹ s...

This paper describes a method for removing oxide film from the surface of silicon wafers using an inert gas fusion impulse furnace and precise determination of bulk oxygen within the wafer. A silicon wafer was cut to about 0.35 g (6 x 13 x 2 mm) and dropped into a graphite crucible. The sample was then heated for 40 s at 1300 degrees C. The wafer's oxide film was reduced by carbon and removed a...

The scanning tunneling microscope (STM) was used to follow the in situ anodic oxidation of highly oriented pyrolytic graphite (HOPG) in 0.1 M H2S04. Prior to electrochemical cycling, the HOPG surface appeared atomically flat and atomic structure was observed with the surface under potential control. Cycling between 0.0 and 1.8 V vs AgQRE (silver wire quasi-reference electrode) resulted in the f...

Exploiting the emulsification properties of low cost, environmentally safe Gum Arabic we demonstrate a high yield process to produce a few layer graphene with a low defect ratio, maintaining the pristine graphite structure. In addition, we demonstrate the need for and efficacy of an acid hydrolysis treatment to remove the polymer residues to produce 100% pure graphene. The scalable process give...

The time-consuming and challenging preparation of graphene, however, has resulted in the increased interest in graphene oxide (GO). [ 15 ] GO, the oxidized form of graphene, is easily generated through the oxidation and subsequent exfoliation of graphite. The oxygen functional groups enable GO to be dispersed in polar solvents (i.e., water) and further functionalized. However, because the conju...

Few-layer graphene has been prepared by electrochemical intercalation of graphite cathode using Na/ dimethyl sulfoxide complexes as intercalation agent. By adding thionin acetate salt into the electrolyte, the exfoliated graphite is stabilized and further exfoliated into few-layer graphene. Raman and X-ray photoelectron spectra indicate that the graphene material has lower content of defects an...

Electrochemical impedance spectroscopy, EIS, has been applied for characterization of electrochemically modified graphite electrodes in the sulphuric acid solution. Graphite modifications were performed by potential cyclization between potentials of graphite oxide formation/reduction, different number of cycles, and prolonged reduction steps after cyclization. Impedance spectra measured at two ...

Graphite oxide constitutes carbon network with oxygen atoms both on hexagonal arrangement and the edge sites. Structural and electronic properties for graphite-oxygen complexes have been explored using first-principles total-energy calculations within the local density approximation (LDA). Band structures and density of states for the propose carbon 3D models are reported. A finite energy gap and...

Reduced porous graphene oxide as a metal free catalyst was selected for the oxidative dehydrogenation of ethylbenzene to styrene. It showed the best catalytic performance compared with other carbon materials (routinely reduced graphene oxide, graphite powder and oxidized carbon nanotubes) and commercial iron oxide.