The control of flow balance at the die exit is key for successful extrusion polymers. complex cross-sectional variation in real-world hollow profiles intrinsically promotes imbalance cavity. Special considerations are required designing dies such profiles. design a door frame profile was computationally optimized this study with aid commercially available software package. velocity distribution...

The simultaneous flow of oil and water in porous media is described by relative permeability curves, mainly derived from laboratory experiments. Relative permeability is of paramount importance in predicting reservoir production performance and drive mechanisms and its value depends largely on the volume fraction of fluids present in the test samples. Nowadays X-ray scanners are one of the most...

Headwater accident is a natural phenomenon that occurs in every flow channel, resulting in tremendous incidents that involve vulnerable lives and destruction of its surroundings. This study focuses on simulation of potential headwater accidents at Lata Kinjang waterfall (Perak, Malaysia) with the aim of understanding the behavior of headwater accidents from the hydraulic aspect. By deploying th...

in this study, changes in speed and turbulence intensity in the wake of a peugeot model and the drag coefficient changes with increases vehicle speed in unsteady flow measured and evaluated. the blow open circuit wind tunnel to simulate fluid flow is used. disturbances and nominal maximum speed of the device, respectively is, 30 m / s and 0.01%. has been continuously increasing speed by an inve...

MHD boundary layer flow of two phase model nanofluid over a vertical plate is investigated both analytically and numerically. A system of governing nonlinear partial differential equations is converted into a set of nonlinear ordinary differential equations by suitable similarity transformations and then solved analytically using homotopy analysis method and numerically by the fourth order Rung...

BACKGROUND Flow-rate dependencies of the Doppler continuity equation are addressed in this study. METHODS AND RESULTS By use of computational fluid dynamic (CFD) software with turbulence modeling, three-dimensional axisymmetric models of round stenotic orifices were created. Flow simulations were run for various orifice area sizes (0.785, 1.13, 1.76, and 3.14 cm2) and flow rates (0.37 to 25.0...

In vacuum assisted resin transfer molding (VARTM) process, fiber preform defects result very often from inappropriate placement at edge regions when the fiber preform has three-dimensional shape. The unintentional permeability variation is difficult to detect by viewing through the transparent vacuum bag. In this paper, a method was proposed for detecting the local permeability variation of the...