Introduction Total joint arthroplasty (TJA) is commonly used to alleviate the debilitating effects of arthritis. Nevertheless, up to 25% of TJA cases will require surgical revision due to implant failure. The generation of wear debris through articulation of the artificial joint is considered one of the prime factors promoting the chronic inflammation that leads to implant failure. Previous stu...

Wear behavior is influential to improve friction drive and wear lifespan of actuators or motors, which work at an elliptical locus vibration. Sliding wear tests of metallic friction pairs are conducted by a laboratory rig of ultrasonic vibration. Surfaces of the different metallic sliders are characterized using surface roughness, Abbott curves and fractal dimension. Results show that surface r...

Worn, flat occlusal surfaces and anterior edge-to-edge occlusion are ubiquitous among the dentitions of prehistoric humans. The concept of attritional occlusion was proposed in the 1950s as a hypothesis to explain these characteristics. The main aspects of this hypothesis are: 1) the dentitions of ancient populations in heavy-wear environments were continuously and dynamically changing owing to...

An operating system contains a replaceable unit whose wear (i.e. accumulated amount of damage) can be observed over time. When the wear reaches a certain level the unit is no longer able to function satisfactorily and needs to be replaced. Although units are produced to the same nominal specification there is still some random variation among them in their wear rates. This will be expressed by ...

The ABG I cementless hip prosthesis has demonstrated unacceptably high rates of wear and osteolysis in our patients. We performed a retrospective study of 97 hips implanted between 1992 and 1998. Radiographic analysis revealed high rates of wear of the polyethylene liner with marked peri-acetabular osteolysis. Clinical examination indicated that many of these patients were initially asymptomati...

Ultra-high molecular weight polyethylene (UHMWPE) wear in total knee arthroplasty (TKA) components is one of the main reasons of the failure of implants and the consequent necessity of a revision procedure. Experimental wear tests are commonly used to quantify polyethylene wear in an implant, but these procedures are quite expensive and time consuming. On the other hand, numerical models could ...

Wear due to relative motion between component surfaces is one of the primary modes of failure for many engineered systems. Unfortunately, it is difficult to accurately predict component life due to wear as reported wear rates generally exhibit large scatter. This paper analyzes a reciprocating tribometer in an attempt to understand the instrumentrelated sources of the scatter in measured wear r...

background: some studies have shown that casein phosphopeptide-amorphous calcium phosphate (cpp-acp) and acidulated phosphate fluoride (apf) gel can protect teeth against erosion. the aim of this study was to assess whether cpp-acp and fluoride could reduce enamel wear rates under erosive conditions simulating abrasion and acidic diet regimen. materials and methods: enamel specimens consisted o...

aa8090 is an extra light and deformable group of lithium containing aluminum alloys which have recently replaced some aerospace aluminum alloys, such as 2000 and 7000 series, due to their higher elastic modulus and lower specific weight. in this study, aa8090 matrix composites containing 3, 6 and 9 vol.% sic were cast using a modified stir casting method. the casting billets were deformed thoug...