Introduction: The fracture mechanisms of bone tissue have been described as a damage accumulation process, which starts with the initiation and propagation of microcracks. Knowledge of crack initiation and propagation at tissue level (tissue fracture toughness) is critical to understand and prevent bone fractures. Tissue fracture toughness could provide valuable information for defining bone qu...

Smart film crack monitoring method, which can be used for detecting initiation, length, width, shape, location, and propagation of cracks on real bridges, is proposed. Firstly, the fabrication of the smart film is developed. Then the feasibility of the method is analyzed and verified by the mechanical sensing character of the smart film under the two conditions of normal strain and crack initia...

The rate/temperature dependent fracture behaviour of plain and glass-filled polystyrene has been investigated over the crack speed (a) range of 10 -6 to 10 -2 m sec -1 and in the temperature (7-) range of 296 to 363 K. The Kc (a, T) relationships obtained, where Kc is the stress intensity factor at fracture, are shown to follow those given by the Williams/ Marshall relaxation crack growth model...

Ultra High Cycle fatigue leads to a failure initiated in the bulk material of a material. Some results on the nodular cast iron are presented: initiation occurs from the defects, located at the surface or in the bulk. It has been shown that environment plays a major role that could explain the difference between fatigue lives, for the surface and internal initiation. The influence of the defect...

To clarify the internal fatigue crack generation in a Ti-Fe-O (near a-type) alloy, microstructures, internal fatigue crack initiation sites, and dislocation structures in samples fractured during high-cycle fatigue tests at liquid nitrogen temperature were studied. The alloy contained two kinds of elongated a-phase microstructures, i.e., recovered a grains and recrystallized a grains. Untested ...

In this study, the problem of finding the limiting load in infinite plates with internal cracks is extended to the non-linear field. In particular, results concerning concrete plates in bi-axial loading are shown. The analysis is performed in discrete form, by means of the Cell Method. The discrete analysis allows us to identify the crack initiation without using the stress intensity factors. T...

This paper presents the results of a combined experimental and theoretical study of the fatigue crack initiation in LIGA Ni thin films with a thickness of 270 mm. The potential roles of surface oxide thickening and slip bands are explored for fatigue crack initiation. Surface oxides and roughness are characterized using X-ray photoelectron spectroscopy (XPS) and atomic force microscopy (AFM). T...

Based on the strain rates of 2 × 108 s−1 and 2 × 1010 s−1, molecular dynamics simulation was conducted so as to study mechanisms of crack propagation in nanoscale polycrystal nickel. The strain rate has an important effect on the mechanism of crack propagation in nanoscale polycrystal nickel. In the case of a higher strain rate, local non-3D-crystalline atoms are induced and Lomer-Cottrell lock...

Serial mechanical sectioning and high resolution X-ray tomography have been used to study the three-dimensional morphology of small fatigue cracks growing in a 12 Cr tempered martensitic steam turbine blade material. A range of surface conditions has been studied, namely polished and shot peened (with varying levels of intensity). In the polished (unpeened) condition, inclusions (alumina and ma...