As the beam propagates in the University of Maryland Electron Ring (UMER) complex transverse density structure including halos has been observed. A primary objective of the experiment is to understand the evolution of a space-charge-dominated beam as it propagates over a substantial distance. It is therefore important to understand which details of the beam structure result from propagation of ...

In this paper, low energy electron beam (5–20 keV, 0–500 lAs/cm) induced damage on a GaN/ InGaN/GaN near-surface quantum well structure is studied. Exposure to low energy electron beam is shown to significantly reduce the optical quality of the structure. It is also observed that reducing the electron beam energy causes larger PL intensity reduction. This can be explained by considering the bea...

This paper features the modeling and design of a Fast Output Sampling (FOS) Feedback control technique for the Active Vibration Control (AVC) of a smart flexible aluminium cantilever beam for a Single Input Single Output (SISO) case. Controllers are designed for the beam by bonding patches of piezoelectric layer as sensor / actuator to the master structure at different locations along the lengt...

A finite element solution based on equevalent elements is proposed for the static and dynamic analysis of tallhigh tensioned cable antennas. To reduce high number of degrees of freedom in space frame body of a structure, a simple equivalent beam element is defined for each simulative substructure. This numerical procedure is applicable to analyze complex three dimensional assemblies of substruc...

The beam structure is an essential structural element for construction professionals, and most engineers should be familiar with beams. type of discussed in this paper a simple structure. Calculating the forces deformations numerically takes longer require good accuracy. In increasingly sophisticated era, various kinds software are available, one which SAP2000, can used to obtain internal quick...

In this paper, a pressure sensor for low pressure detection (0.5 kPa-40 kPa) is proposed. In one structure (No. 1), the silicon membrane is partly etched to form a crossed beam on its top for stress concentration. An aluminum layer is also deposited as part of the beam. Four piezoresistors are fabricated. Two are located at the two ends of the beam. The other two are located at the membrane per...