Foam fraction can be retrieved from space-based microwave radiometric data at frequencies from 1 to 37 GHz. The retrievals require modeling of ocean surface emissivity fully covered with sea foam. To model foam emissivity well, knowledge of foam properties, both mechanical and dielectric, is necessary because these control the radiative processes in foam. We present a physical description of fo...

The annular foam breaker is one which uses the vacuum and shear force generated by the Coanda effect to break foam. The pressure distribution directly affects its performance. So an investigation on the flow characteristics inside the annular foam breaker is important to optimize its structure. In this paper, the computational fluid dynamics (CFD) code, FLUENT, is employed to simulate the flow ...

Anodic porous alumina has been widely investigated and used as a nanostructure template in various nanoapplications. The porous structure consists of numerous hexagonal cells perpendicular to the aluminum substrate and each cell has several tens or hundreds of nanoscale pores at its center. Because the nanomorphology of anodic porous alumina is limited by the electrolyte during anodizing, the d...

Experimental researches on adsorptive capacity of activated alumina, silica sand and anthracite coal for phosphorus were conducted. Results showed that performances of three filter media were all in line with Langmuir isotherm, and activated alumina adsorptive performance was much better than silica sand and anthracite coal for phosphorus removal. The adsorptive capacity of activated alumina, s...

Mono-phase bio-ceramics (alumina and zirconia) are widely used as femoral heads in total hip replacements (THR) as an alternative to metal devices. Unfortunately, the orthopaedic community reports significant in-vivo failures. Material scientists are already familiar with composites like alumina zirconia. Since both are biocompatible, this could prove to be a new approach to implants. This pape...

Simple nanoporous alumina matrix modification procedure, in which the electrically highly insulating alumina barrier layer at the bottom of the pores is replaced with the conductive layer of the gold beds, was described. This modification makes possible the direct electron exchange between the underlying aluminum support and the redox species encapsulated in the alumina pores, thus, providing t...

INTRODUCTION Incorporating a feldspar chemical bond between alumina filler particles is expected to increase the wear-resistant and flexural strength properties. AIMS AND OBJECTIVES An investigation was carried out to evaluate the influence of the feldspar chemical bonding between alumina filler particles on wear and flexural strength of experimental alumina/feldspar dental composites. It was...

Hydroxyapatite/alpha-alumina composites were prepared by means of high-energy vibratory ball milling. The effect of the addition of alumina, from 5 to 25 wt%, was investigated. x-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FT-IR) results indicated thathydroxyapatite andaluminawere themajorphases aftermechanicalmilling and only small peak shifts were observed. Transmission...

Foam flooding (or injection of foam) is a common technology to enhance oil recovery. Although the effects of permeability on foam flooding were well studied in many laboratory experiments, little research has been focused on the specificity of low permeability. In this paper, a series of constant-quality nitrogen foam flow experiments were conducted to investigate the effects of permeability on...