In this paper, a technique for suppressing the transient states of IIR notch filters is presented. This technique mainly uses the vector projection to find the good initialization of a notch filter. When a notch filter is used to cancel 60 Hz interference in the recording of electrocardiograms (ECG), the performance of the notch filter with transient suppression is better than that of the notch...

This paper presents a two-stage approach for designing an infinite impulse response (IIR) notch filter. First, the numerator of the transfer function of the IIR notch filter is obtained by placing the zeros at the prescribed notch frequencies. Then, the denominator polynomial is determined by using an iterative scheme in which the optimal pole placements are found by solving a standard quadrati...

Adaptive notch filters (ANF) are widely used in many signal processing applications to extract, eliminate or trace narrow-band or sinusoidal signals embedded in broadband noise [1]. If such signal consists of in-phase and quadrature components, a complex coefficient ANF must be implemented. Most of such applications are in radar and communication systems. To yield sharp-cutoff bandpass characte...

In Digital Signal Processing, there are different applications are found for Filters. The filters are categorised and designed as IIR filter or FIR filter for different applications dependent upon impulse response. In this paper a notch filter is designed of high quality factor to cut specifically 100Hz. This notch frequency is chosen because at that frequency some noise may be observed or harm...

This paper is concerned with the two-dimensional (2-D) linear-phase FIR notch filter-design problem. First, the singular value decomposition (SVD) is used to reduce the 2-D notch filter-design problem to two pairs of one-dimensional (1-D) filter design problems. Then, we derive an analytic least-squares solution for the design of two pairs of 1D linear-phase FIR filters. Again, the coefficients...

This paper presents an experimental verification of ultra-wideband bandpass filter (BPF) for UWB applications and notch filter in order to suppress 5 GHz narrowband service when it coexists with UWB radio system. The BPF consists of a hexagonal shaped multiple mode resonator (MMR) with interdigital coupling at both sides. Notch filter is derived from BPF by introducing four embedded open stubs ...

Based on symmetry of the maximally flat frequency response of a FIR notch filter the new design procedure is developed. The closed form solution provides direct computation of the frequency response, recursive computation of the impulse response coefficients, simple windowing technique, and an access to new implementation. Several examples are included. INTRODUCTION In order to remove a single ...

Public-address system has been widely used in many applications to amplify speech and music signals. In such environments, an acoustic feedback from a loudspeaker to a microphone usually exists and it may causes howling which explosively increases a certain frequency amplitude. The howling is a persistent and an annoying problem in many acoustic enviroments. To solve this problem, we have previ...

In this paper, tunable microstrip bandpass filters with two TUNABLE BANDPASS FILTER SCHEMATIC AND OPERATION. Fig. 1 shows. A. Melloni, and F. Morichetti, “Tunable photonic circuits: a leap toward tunable microstrip bandpass filter using thin-film Barium-StrontiumTitanate (BST). -Electrical circuits and calculus class tutor (Sp 2013, Fa 2013). -Design tunable capacitors (varactors) and band-stop...