The design of an advanced controller for wind turbine load mitigation is presented. The controller is based on Nonlinear Dynamic Inversion control methods combined with Pseudo Control Hedging to account for the actuator limits and a two degree of freedom control system for the collective pitch control of the rotor blades. The controller uses wind speed measurement information to adjust to wind ...

The type of turbine developed is based on the very low head of water potential source for the electric power production. The area of research is focused for the axial water turbine that can be applied at the simple site open channel with has a very low cost and environmental impact compared to the conventional hydro installation. High efficiency of axial turbine which applied to the very low po...

Stress Concentration Factors are significant in machine design as it gives rise to localized stress when any change in the design of surface or abrupt change in the cross section occurs. Almost all machine components and structural members contain some form of geometrical or microstructural discontinuities. These discontinuities are very dangerous and lead to failure. So, it is very much essent...

Nowadays, trailing edge flaps on wind turbine blades are considered to reduce loading stresses in wind turbine components. In this paper, an optimal control synthesis methodology for the design of gust load controllers for large wind turbine blades is proposed. We discuss a control synthesis approach that minimises the power expenditure of the actuated trailing edge flap, while at the same time...

Helium gas turbine is the key component of the power conversion system for direct cycle High Temperature Gascooled Reactors (HTGR), of which an optimal design is essential for high efficiency. Gas turbine design currently is a multidisciplinary process in which the relationships between constraints, objective functions and variables are very noisy. Due to the ever-increasing complexity of the p...

A building design of vertical axis wind turbines (VAWT) was presented in the article. The construction and operating principle of a wind turbine were described therein. Two VAWT turbine models were compared, i.a. Darrieus and Lenz2, taking their strengths and weaknesses into consideration. 3D solid models of turbine components were presented with the use of SolidWorks software. Using CFD method...

The aim of this paper is to investigate the performance of a specially designed micro wind turbine for urban environment where the wind speed is usually low. Differing from the traditional wind turbine that can be connected directly to the grid, the micro wind turbine is linked to a small generator and mainly used for local applications. The advantage of the micro wind turbine is that, apart fr...

The high-speed dental air-turbine handpieces are widely used in the dentistry as a tool for cutting and drilling a tooth. The advanced existing high-speed dental air-turbine handpieces were investigated to design the high performance dental air-turbine handpiece. The coupler and air-turbine of the dental air-turbine handpiece was designed using computational analysis. The computational domain o...

In this paper, using sliding mesh model, the numerical simulation of small vertical axis wind turbine aerodynamic performance was studied with FLUENT software. Got change rule of four same thickness and different camber‘s NACA series asymmetrical airfoil moment coefficient of the wind turbine and wind power machine with the tip speed ratio. Wind turbine benchmark blade around the flow field was...

This study presents an application of a distributed service-oriented architecture (FIPER) for the preliminary design of gas turbines. The FIPER architecture is based on the concept of registration and discovery of services in real time. It uses a service catalog that registers the services started on the network. These services are then discovered in real time from the grid and used in the desi...