.Hot metal gas forming of tubes can be used in various industries such as automotive and aerospace industries. In this process tube is formed at elevated temperatures, by using gas instead of fluid pressure. Lower required pressure and low power are its advantages in comparison to hydroforming process. In this paper, a hot metal gas bulging process of an aluminum alloy tube has been investigate...

forming limit curve (flc) is an important tool for evaluation of formability of sheet metals subjected to different loading. free bulge of aluminume tubes has been investigated numerically to obtain flc. to verify the numerical results one experimental setup has been manufactured which has the ability of controlling the internal pressure and axial feed. in this study, time and zone of bursting ...

Dual-pressure tube hydroforming (THF) is a tube-forming process that involves applying fluid pressure to tube’s inner and outer surfaces achieve deformation. This study investigates the effect of dual-pressure loading paths on material formability tribological conditions. Specifically, pear-shaped triangular cross-sectional parts were formed using modes where inside tubular blank was alternated...

The tensile deformation is the most common forming principle in sheet process, but there a new tube process—tube hydro-forging has been developed based on of compression deformation. In addition to instability problem, surface defect—thickness distortion—was found this paper, wall thickness distortion analyzed from point view mechanics and It revealed that low pressure hydroforming bending mome...

in this study, an extended stress-based forming limit diagram (fld) for prediction of necking based on the marciniak and kucznski (m-k) model is represented and applied in tube hydroforming. the bulge forming of a straight tube is simulated by finite element method and verified with published experimental data. this adaptive simulation technique is based on the ability to detect the onset and g...

During the last few years, several sheet hydroforming processes have been introduced. Despite the advantages of these methods, they have some limitations. Of the processes, the two main ones are the standard hydroforming and hydromechanical deep drawing. A new sheet hydroforming die set was proposed that has the advantages of both processes and eliminates their limitations. In this method, a po...

forming limit curve (flc) is an important tool for evaluation of formability of sheet metals subjected to different loading. free bulge of aluminume tubes has been investigated numerically to obtain flc. to verify the numerical results one experimental setup has been manufactured which has the ability of controlling the internal pressure and axial feed. in this study, time and zone of bursting ...